Question about Microwave Ovens

2 Answers

Can you please advise me where could I buy burner supports tops x 4 (in grey or black) for Cannon SP1 gas hotplate 1974 model ... I live in the Melbourne/Bentleigh area ... thanks

Posted by on

  • 1 more comment 
  • raywilliams4 Mar 25, 2011

    did not answer my request (microwave oven?) ... asked where I could purchase burner tops in Bentleigh area for Cannon GAS HOTPLATE TOP

  • raywilliams4 Mar 25, 2011

    Companies listed unable to supply ... can you suggest any more that deal in CANNON gas Hotplate spares?

  • raywilliams4 Mar 28, 2011

    not much ... just as good "Googling"

×

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 5,081 Answers

A.N.Z. Appliance Parts
---------------------------------
Factory 3,
15-17 Tower Crt.
Noble Park
Victoria, 3174
Phone: 03 9798 6000

Posted on Mar 25, 2011

  • INDIRA KUMAR
    INDIRA KUMAR Mar 25, 2011

    Thermal Products Pvt LTD
    -------------------------------------
    178 - 180 Holt Pde,
    Thomas-town VIC 3074
    Ph: (03) 9464 0822

  • INDIRA KUMAR
    INDIRA KUMAR Mar 25, 2011

    Can you try to buy it athttp://www.zingappliances.com.au/

×

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 1,998 Answers

Www.marcone.com has the largest selection of appliance parts in the world and they ship anywhere in the world as well or you can click here for there international phone number http://www.marcone.com/ContactUs.aspx if you have any problems after you contact them with them locating the part for your unit please message me back and i can check other avenues for locating your part this is the main parts supplier that i personally use when repairing all the equipment that I do repair so give this a try and message me back. Although sometimes when a unit becomes very old it becomes near to impossible to find a specific piece due to the companys that manufactureing the pieces decide ok where done with this one we are not going to make any further parts this way they just break down and cannot be repaired this is what thermodor does after a customer spends 8-10,000 and 5 years later the discontinue the pieces Once again try marcone and message me back with how you made out Thanks again Rick

Posted on Mar 25, 2011

  • Rick Ead
    Rick Ead Mar 25, 2011

    ok have you tried this place http://4cannon.co.uk/cgi-bin/home.pl have you also tried directly contacting cannon check out these links a couple have older parts if you scroll through them http://www.appliancespartsdirect.com/spa... this one lists the hotplate electrode for that unit http://www.appliancespartsdirect.com/can... if that hotplate electrode is not what your looking for message me back what exactly you are looking for along with serial and model numberof the unit there is also a place i am aware of located in massachuesetts that finds parts that have been discontinued wont be able to get that information on it further till after april 1st heading back across the country to go back to east coast area when i get back there i can put a link on that site of the exact part that your looking for or you can let me know how you made out and if you have called cannon directly to ask there customer service need a bit more information on which part exactly your looking for Thanks Rick

  • Rick Ead
    Rick Ead Mar 28, 2011

    question have yout tried contacting cannon directly?also exactly which piece of the hotplate are you looking for is it the electrode or the actual burner assembly? Thanks Rick

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a gas Viking range. The oven burner ignitors light up and ignite the gas burners but quickly shut off - then go on again and off again- intermittently but frequently. This does not permit the...


Hi,
Here is a test you can use to check the ignitors, Ignitor test. I also would like to you turn the thermostat knob slowly from the off position, When do you hear the click in the knob? You should hear it before the warm or lowest numbered setting on the knob. If you don't, replace the thermostat as it has failed. Need full model number to get you part.
Good Luck
Stay dry out there!!

Aug 28, 2011 | Microwave Ovens

1 Answer

Hot plate just wont turn on...switches checked in meter box and no iscolating switch. baumatic ceramic cook top. BA 13.2 ( i think) house just been sold. Hotplate wked thurs. House sold Fri. new owner...


Hello, is this a two electrical filament hot plate? Also, is this range stove/oven? I'm a little confused here on what exactly what you are referring to hot plate or cook stove with electrical burners and oven. If it a really old hot plate with one burner look at the plug there could be a fuse in it. If it is electrical range then check the control board and see they a fuse on. If not, check the voltage with a volt meter. Be very careful here there two phase that is 240 Volts AC. The voltage will be split between the two l20 hot legs AC which is 120 degrees out of phase in respect to each other; in other words, don't both of them don't let them touch each other.


If it a kitchen stove I'm fairly sure that the control board is shot and with this not operating it will not open the current/voltage relays for the electrical burners. REMEMBER YOU ARE DEALING WITH 240 VOLT AC...BE CAREFUL.... GB....stewbison

Aug 26, 2011 | Baumatic Microwave Ovens

1 Answer

Ignitors continue to pop altho all four knobs are in off position Kitchenaid gas stove top Model #KGCT305X Serial #XB2806974 ir X52606974


Hi,
Here is a tip that I wrote that will help figure out why the burner spark keepson clicking...

Gas Range Repair Burners Keep on Clicking
heatman101

Apr 21, 2011 | Microwave Ovens

1 Answer

My Jen-Air Gas cook top ignitors keep clicking when one or all 4 are lit can this be stopped


Hi,


Here is a tip that I wrote that will help figure out why the burner spark keeps on clicking...

Gas Range Repair Burners Keep on Clicking


heatman101

Apr 16, 2011 | Microwave Ovens

1 Answer

We installed our new gas stove now. I would like to know if al the burners' sparks will fire if one knob is pressed in?


This is a pretty common practice; there is normally only one high voltage source, not one for each burner, and is routed to all of them any time one range-top control is depressed. This eliminates the need for 4 individual special high voltage switches to route them to one burner at a time.

Jan 15, 2011 | Microwave Ovens

1 Answer

User manual for cannon chester gas cooker


This was very difficult to find, but I found it just for you! Please make sure you rate my answer 4 thumbs up! Thanks so much for understanding, it would be a huge help to me. I would be forever grateful if you could do this for me. To view the manual you will need adobe reader, which you can get for free from http://get.adobe.com/reader/ You probably already have it though, please try opening the file first and find out. Here is the manual / guide please give it a few minutes the file is quite large:


http://imagebank.indesitcompany.co.uk/brochures_online/pdf/cannon/Chester%20MK3_10540G_10545G_10548G_19504061204.pdf

Oct 15, 2010 | Microwave Ovens

1 Answer

On Dacor cook-top. LP gas, what is recommended pressure (inches of water) in manifold? Have one burner of 6 that blackens cookware.


Hi,
For LP you should be right around 10" WC....to high of pressure will give too much gas and burn rich... and make the soot that makes the cookware black...

heatman101

Sep 14, 2010 | Dacor Microwave Ovens

1 Answer

The pilot and burners will not stay lit and,the ignitor keeps trying to light.its a 4 burner flat top.


Normal 0 MicrosoftInternetExplorer4 st1\:*{behavior:url(#ieooui) } /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:""; mso-padding-alt:0in 5.4pt 0in 5.4pt; mso-para-margin:0in; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:10.0pt; font-family:"Times New Roman";} Hi,

Here is a tip that I wrote that will help figure out why the burner spark keeps on clicking...

Gas Range Repair Burners Keep on Clicking

heatman101

Sep 13, 2010 | Microwave Ovens

1 Answer

When one of the gas hobs is on ,it does not burn with a blue flame but a more yellow one .also black soot forms under the burner plate.it is on lpg


Have to adjust the piolot lights for the amount of gas coming out. U have too much gas coming out(yellow flame). On older gas ranges, there was a small screw between the piolot light & burners that had to be adjusted. (if this is a older model) have to turn the screw just a little at a time, till ur flame returns to blue on ur burners. Hope this helps.

Sep 12, 2010 | Microwave Ovens

1 Answer

My gas hotplates ignition switches are not working. How do I fix this.




Hi,

Here is a tip that I wrote to give details about why your cooktop will not spark to light the burners..

Cooktop Range Stove spark ignition does not work

heatman101

Sep 02, 2010 | Microwave Ovens

Not finding what you are looking for?
Microwave Ovens Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Microwave Ovens Experts

William Miller
William Miller

Level 3 Expert

9047 Answers

Devabhakthuni...
Devabhakthuni...

Level 2 Expert

225 Answers

yadayada
yadayada

Level 3 Expert

75744 Answers

Are you a Microwave Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...