Question about Frigidaire Dryers

1 Answer

Dryer stops after a few(10-15) minutes and all the lights blink until the cancel button is pushed. All cycles start normally immediately afterward.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Vice President:

    An expert whose answer gotĀ voted for 100 times.

    Champion:

    An expert who has answered 200 questions.

  • Contributor
  • 239 Answers

I suspect the control is losing power and resetting itself. It will likely need to be replaced.

Kelly

Posted on Mar 24, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to turn off demo mode?


Good Morning Friend,

I understand you want to turn the demo mode off of your Electrolux dryer, model# EWED65H. To deactivate the demo mode in your appliance, please try the following:

    1)Turn the cycle knob to the last cycle on the right.
    2)Press the start button and immediately afterwards press the cancel button.
    3)Within 10 seconds, wake up your appliance by pressing the start button once.
    4)Immediately, press and hold cancel and the right most key under the display, together for a minimum of 6 seconds. DEMO MODE will no longer show in the display.
    5)If a 3 prong power cord (120V cord) is attached, remove it and attach normal 240 V cord.


    I ask that you please follow up with a comment on the post, at your convenience, to advise if further troubleshooting is needed or if your appliances status has changed successfully. Hope this is helpful.

    -Best Regards-
    WP

Jul 03, 2014 | Electrolux EWED65H Dryer

1 Answer

Fisher Paykel DS605i single dishdrawer with a user-supplied integrate panel. There are three buttons on front. The left-hand button is power button; the center button is start/pause; and the right-hand...


Hello, Thank You for using FixYa. I will be helping you today.Are any of the cycle lights lighting up like rinse and normal and is the light on front blinking and pausing if so how many times is it blinking? Try turning the power off too the unit for five minutes and back on, because if the lid was open some or was stuck it can stop the unit from running.
Thank You and please ACCEPT my answer and Rate my answer if it was helpful..

Jun 29, 2011 | Fisher and Paykel 23 in. DD-603SS Built-in...

1 Answer

My kenmore dishwasher, model 15822, just stopped working. The quick rinse light is blinking. The only other buttons that work are the pots & pans light which blinks when pushed, and the cancel button...


These are known to develop sticky switch contact pads. They stick in the contacted position and stifle the panel. Sometimes heat can be applied with a hair dryer to release them and make the unit function again. This is more than likely a temporary fix. New panels are available for about $165 to $200.

Jul 16, 2009 | Kenmore Dishwashers

1 Answer

Icemaking cycle automaticall self stops and cleaning light blinks


ice machine runs one cycle and freezes ice will not release ice block to wire cutter. then after a few minutes the cleaning light starts blinking

Jun 11, 2009 | Kenmore 51lb. Clear Ice Maker

1 Answer

Whirlpool Dishwasher won't drain during normal cycle


As you say a clogged line or valve does not make sense.

Try running it without the heated drying and see if it empties or if the cancel button will work then.

The dishes should air dry quickly if you empty it and open the door.

It could be a defective thermostat allowing it to get too hot during the heat cycle

May 18, 2009 | Dishwashers

1 Answer

Kenmore Ultra Wash Dishwasher LIghts are blinking....


I suspect for either of these units that the timer control boards are bad.

Jan 24, 2009 | Dishwashers

2 Answers

Kenmore Ultra Wash Dishwasher LIghts are blinking....


I just read this for the same problem: push sanitize, then heat and dry, sanitize, heat and dry, sanitize, heat and dry, cancel, then open and close the door. It worked. The dishwasher is running correctly even as I type this. 

Feb 11, 2008 | Kenmore 24 in. 17262 Built-in Dishwasher

1 Answer

Keeps stopping


I have a feeling you are buying a timer board.

Dec 11, 2007 | Kenmore Elite HE4 Electric Dryer

5 Answers

"Clean light" keeps blinking; dishwasher won't start new cycle


close the door and to cancel that just press hi temp and hetaer dry again hi temp and heater dry and all the lights is gonna light up, it getting into test mode.
After that press cancel
Now get somebody to replace the thermistor of your machine

Feb 19, 2007 | Kenmore 24 in. 17032 Built-in Dishwasher

Not finding what you are looking for?
Dryers Logo

Related Topics:

205 people viewed this question

Ask a Question

Usually answered in minutes!

Top Frigidaire Dryers Experts

Dan Webster
Dan Webster

Level 3 Expert

8220 Answers

Tim Whalen

Level 3 Expert

3074 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Are you a Frigidaire Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...