Question about Sony KDF-E50A10 50 in. LCD HDTV

2 Answers

Standby mode When you turn the tv on it goes to standby mode. It will come on automatically for 15 seconds the go back to standby mode for for 20 sec and repeat process over an over. Don't know what to do to stop it.

Posted by on

  • Anonymous Aug 15, 2008

    I have the same problem. TV (sound and picture) comes on and stays on for 20 or so seconds, then goes off and green light flashes, then comes back on again. It does this over and over again.

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

I have the same television. Mine would shut off and turn back on every 30 seconds. Even though the LAMP light wasnt coming on in the front of the set, I replaced the lamp with a factory Sony lamp and have had no problems since. The sets picture is beautiful and I have had no problem since.

Posted on Nov 05, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 320 Answers

Replace the lamp first to see if that fixes it. It sounds like a weak or old lamp. Use an original Sony lamp as the aftermarkets are **** and unreliable

Posted on Oct 18, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Turns off after about 20 seconds..


Fault to its main board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. http://electronicshelponline.blogspot.com/ . In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary.

Aug 18, 2015 | Vizio Flat Panel Televisions

2 Answers

My 15 month Celcus LCD423D913FHD tv will not turn on. The standby light is lit and will flicker but will not power up the tv. What is the likely problem?


Fault with its main board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. http://electronicshelponline.blogspot.com/ . In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary.

Oct 20, 2014 | Flat Panel Televisions

1 Answer

My pioneer plasma tv in standby mode and wont turn on


Try restting it by unplugging the tv for a few mins and it should rest to original factory default settings but leave it unplugged 10-15 mins to be sure.

Dec 18, 2011 | Pioneer PDP-4270HD 42 in. Plasma...

1 Answer

When power turn on tv goes in to standby mode when you press standby button on the remote control for split second the blue comes on then goes back to standby mode


Hi these pioneers are difficult to work on you are better off taking it to a technician you will save a lot of headaches trying to fix it. If you still want to do it the first thing I would suspect is teh siganl board.

You can get parts for this tv at www.interliquidparts.com

Dec 18, 2011 | Pioneer PDP-4270XD 42 in. HD-Ready Plasma...

1 Answer

Will not power up. Stays in standby mode.


these particular tvs are very sensitive to voltage changes spikes etc.first turn off main power switch wait at least 30 sec if standby come on wait another 30 then turn off main power again and unplug tv for 1 min then plug in turn on main switch wait 30 sec then turn on tv with remote resets system.then buy a ups and always wait at least 30 min after turning tv off to turn back on if not causes power failure and after each press of power button wait 30 seconds before trying again lmk good luck

Jan 08, 2010 | Hitachi 42HDS69 42 in. Plasma Television

2 Answers

40'' Sony Bravia goes into standby with the light blinking 9 times


I finally managed to solve this problem by unplugging everything - scarts - HDD cables - power etc and left it for an hour. When I turned it back on again the problem had sorted itself out.

Sep 30, 2009 | Sony Flat Panel Televisions

1 Answer

My TV is going into standby mode whenever it is turned on


My screen turns black and the TV goes into standby mode (I get an Amber Light) within 3 seconds after turning the TV on.

Dec 16, 2008 | Flat Panel Televisions

3 Answers

Picture and sound cuts off ,greem stb light keeps blinking TV turns on after 30 secs shuts off after 30 secs comes back on. Continious loop


How many blinks do you get? Depending on the amount of blinks you can figure out what the issue is.

If it blinks 6 times you can get the fix at

No power RED Standby LED flashes 6 times/KDF55XS955, KDF60XS955, KDFE55A20, KDFE60A20

They have other fixes for E60A20

http://www.agoraquest.com/viewtopic.php?topic=31806&forum=70&keyword2=electronics

Dec 28, 2007 | Sony KDF-E60A20 60 in. LCD HDTV

Not finding what you are looking for?
Sony KDF-E50A10 50 in. LCD HDTV Logo

Related Topics:

323 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Flat Panel Televisions Experts

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

yadayada
yadayada

Level 3 Expert

60769 Answers

Paul Bade

Level 3 Expert

1392 Answers

Are you a Sony Flat Panel Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...