Question about HP Computers & Internet

3 Answers

No sound on HP 1140n desktop computer NO audio

No sound on HP 1140n desktop computer NO audio devices listed under Sounds & Audio Devices Properties Problem with audio configuration Have updated drivers

Posted by on

3 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 54 Answers

Enable the o board sound card from bios

Posted on Mar 23, 2011

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 961 Answers

You should have integrated audio from Realtek (ALC880 chipset). Click "start" at bottm left of your screen. Find "control panel" and click on that to open. In your list, find "Device Manager", right click on that and open. Clcik continue. Click on the box with + next to "sound audio and game controllers" you will get a drop down of your devices. You should see High definition device(Realtek). Right click on that. A window should open where you will see "enable" or "disable" if you see enable click on that and exit. Yo should have a seaker icon in your taskbar at bottom right of screen, right click on that. Click on "playback devices" A window hould come up. you should show a working device but if you don't right click on window. You should see "show disabled devices" click on that and see if that does anything. If at this point you should show a working device in th window. Right click seaker icon again andclick on open volume mixer. Here you can adjust your volume.

Posted on Mar 23, 2011

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 293 Answers

Run your recovery disk or if you lost it, go to control panel and click the add hardware and let it find your hardware that missing. (sound and audio)

Posted on Mar 23, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No audio device


if your computer came with a motherboard disc the sound drivers could be on it

click start control panel administration tools computer management device manager scroll to sound video and game controllers you might see a yellow question exclamation mark? ! or a red X Right click to

reinstall drivers

click start control panel sounds and audio volume advanced speakers make sure you have selected the

(appropriate speakers) also audio you will find 3 drop down lists make sure you have the correct settings there

click start control panel sounds and audio devices select advanced there might be a tick in the mute box untick it
hope this helps you

Apr 16, 2012 | HP Pavilion a1410n (ER890AA) PC Desktop

1 Answer

No audio


if your computer came with a motherboard disc the sound drivers could be on it

click start control panel administration tools computer management device manager scroll to sound video and game controllers you might see a yellow question exclamation mark? ! or a red X Right click to

reinstall drivers

click start control panel sounds and audio volume advanced speakers make sure you have selected the

(appropriate speakers) also audio you will find 3 drop down lists make sure you have the correct settings there

click start control panel sounds and audio devices select advanced there might be a tick in the mute box untick it

hope this helps you

Apr 12, 2012 | HP Computers & Internet

1 Answer

After trying to plug in headphones (in the headphone socket) I have lost all sound on my Toshiba satallite 2040 (Idid have sounds from built in speakers before hand) can you help


Hi

You have not mentioned which operating system you are using.

You might have changed the defaul audio settings.

Vista/Windows 7: Start > Cxontrol Panel > Sounds & Audio Devices > Hardware & Sound > Manage Audio Devices > highlight the external speakers from the list of devices > Set Default > Apply > OK > Restart computer.

Win XP: Start > Cxontrol Panel > Sounds Speech & Audio Devices > Hardware & Sound > Change the Speaker Settings > Advanced > Speaker Setup - select Internal Stereo Speakers > Apply > OK > Restart computer.

I hope this helps.

Aug 27, 2011 | Toshiba Satellite 2450-401 Notebook

1 Answer

After installing windows 7 on my hp compaq dc 7600 CTM, the audio deives case to cme. But when connect with a extenal speak it comes. But the microphone can't contigure. Or can't work.


Hi.

Start > Control Panel > Sounds and Audio devices > Audio > use drop down arrow to reveal list of audio devices and select the correct default audio device > apply > ok.

For the microphone, connect the microphone to the pink audio socket front or back > right click on the speaker icon bottom right near the clock > audio > recording devices > double click on micrphone icon > check settings.

i hope this helps.

Aug 24, 2011 | HP Compaq dc7600 PC Desktop

1 Answer

I can't seem to get PowerPoint to pick up the sound from the microphone..... I have tried every conceivable setting under the sun.... Using Microsoft XP.... Message telling me to go to Multimedia...




Using a microphone with computer

To use any microphone with your computer you will need to enable it in control panel. The following instructions are for Windows XP but are broadly similar for Vista and Win7


Click START, CONTROL PANEL, SOUNDS & AUDIO DEVICES


Click VOICE


In Sounds & Audio Devices Properties window locate SOUND PLAYBACK box. Click the VOLUME button. Make sure that there is not a check-mark in the MUTE box against microphone in the list of devices and that the volume slider is at the top of the scale.


Make sure the MUTE ALL box isn't checked before closing the window.


Now click the VOLUME button in the SOUND RECORDING BOX. Here SELECT microphone as an input source for recording (as opposed to un-checking mute in the playback controls).


NOTE if your microphone is not listed in the 2 sets of volume controls click OPTIONS, PROPERTIES on the tool-bar and place a check against microphone in the list entitled 'show the following volume controls' and then click OK. Same applies for Internal mic.


That should be it.


To adjust audio volume generally.

Under VOLUME tab adjust Device Volume as necessary. Also (under Loudpeaker Settings) click Speaker Volume and adjust slider to suit.


You might put a check mark in the box to show the volume control on the Task Bar so you can go straight to it to make adjustments in the future.

Mar 01, 2011 | Dynex Voice-Certified PC Desktop...

1 Answer

People can not hear my voice but I can here them


You need to enable your microphone



Using a microphone with computer

To use any microphone with your computer you will need to enable it in control panel. The following instructions are for Windows XP but are broadly similar for Vista and Win7


Click START, CONTROL PANEL, SOUNDS & AUDIO DEVICES


Click VOICE


In Sounds & Audio Devices Properties window locate SOUND PLAYBACK box. Click the VOLUME button. Make sure that there is not a check-mark in the MUTE box against microphone in the list of devices and that the volume slider is at the top of the scale.


Make sure the MUTE ALL box isn't checked before closing the window.


Now click the VOLUME button in the SOUND RECORDING BOX. Here SELECT microphone as an input source for recording (as opposed to un-checking mute in the playback controls).


NOTE if your microphone is not listed in the 2 sets of volume controls click OPTIONS, PROPERTIES on the tool-bar and place a check against microphone in the list entitled 'show the following volume controls' and then click OK. Same applies for Internal mic.


That should be it.


To adjust audio volume generally.

Under VOLUME tab adjust Device Volume as necessary. Also (under Loudpeaker Settings) click Speaker Volume and adjust slider to suit.


You might put a check mark in the box to show the volume control on the Task Bar so you can go straight to it to make adjustments in the future.

Feb 22, 2011 | Logitech USB Desktop Consumer Microphone

1 Answer

New microphone will not record...please advise.


There are two separate settings in control panel for record and playback - see below



Using a microphone with computer

To use any microphone with your computer you will need to enable it in control panel. The following instructions are for Windows XP but are broadly similar for Vista and Win7


Click START, CONTROL PANEL, SOUNDS & AUDIO DEVICES


Click VOICE


In Sounds & Audio Devices Properties window locate SOUND PLAYBACK box. Click the VOLUME button. Make sure that there is not a check-mark in the MUTE box against microphone in the list of devices and that the volume slider is at the top of the scale.


Make sure the MUTE ALL box isn't checked before closing the window.


Now click the VOLUME button in the SOUND RECORDING BOX. Here SELECT microphone as an input source for recording (as opposed to un-checking mute in the playback controls).


NOTE if your microphone is not listed in the 2 sets of volume controls click OPTIONS, PROPERTIES on the tool-bar and place a check against microphone in the list entitled 'show the following volume controls' and then click OK. Same applies for Internal mic.


That should be it.


To adjust audio volume generally.

Under VOLUME tab adjust Device Volume as necessary. Also (under Loudpeaker Settings) click Speaker Volume and adjust slider to suit.


You might put a check mark in the box to show the volume control on the Task Bar so you can go straight to it to make adjustments in the future.

Feb 20, 2011 | Dynex Voice-Certified PC Desktop...

1 Answer

Our Compaq desktop computer has internal speakers. For some reason there is no playback sound coming from them though. We bought a new, green audio cord to connect to the CPU and monitor. This still...


Hello
Sounds like the drivers for your audio device are missing or corrupt.

Go to control panel/audio or sound devices and make sure your device is listed and checked to enable.

Next go to Hp compaq.com and find which sound device is in your pc.
Download and install drivers for sound.

Or if you have the cd or dvd that came with the pc the drivers should be on there.

Jan 08, 2011 | HP Compaq Computer Speakers

2 Answers

No sound


1)Check the leads connected to speaker
2)un-install and re-install
3) control panel..sound and multimedia and check the properties.


Hope that helps....keep the hope :)


May 20, 2009 | HP Compaq Business Desktop d330 Slim Tower

1 Answer

How can i enable the sound of my computer?


Start>Control Panel>(Sounds, Speech, and Audio Devices>)Sounds and Multimedia (or Audio Devices)

In here go to Audio (tab at the top). On the sound playback device select, "Volume." Move the main audio playback slider up to increase the volume.

If for some reason there are no audio devices listed in the Sound control panel (unlikely), there is a possibility that your audio ports have been disabled (again, unlikely).

Go to your device manager by right-click My Computer (Either located in your start menu or on your desktop) and go to Properties. Now select, "Hardware." In here click the button, "Device Manager."

The device manager should appear. Look at, "Sound, video, and game controllers." If anything in this category is listed as disabled try enabling it, then exit the device manager.

Jan 30, 2009 | Audio Players & Recorders

Not finding what you are looking for?
Computers & Internet Logo

Related Topics:

323 people viewed this question

Ask a Question

Usually answered in minutes!

Top HP Computers & Internet Experts

Les Dickinson
Les Dickinson

Level 3 Expert

18392 Answers

Doctor PC
Doctor PC

Level 3 Expert

7733 Answers

Tony

Level 3 Expert

2600 Answers

Are you a HP Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...