Question about Gigabyte GA-8ST667-L Motherboard

2 Answers

My cpu fan is not working in my Gigabyte GA-8ST667 system can anyone tell me why am sure the cpu fan is good

Posted by Anonymous on

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 346 Answers

Hello elscomputers: If you are sure that there is no other issue with the motherboard -- It was working before the CPU Fan/Heatsink stopped working. Other than making sure that it is correctly connected as shown below -- attached to Pin 1 with all three pins connected (not off to the side by one pin), you can assume it's bad (they do wear out). The cost of a new cooler is pretty minimal and I would just replace it.

my cpu fan is not - mikeywaf_6.gif



Good Luck and Thanks for inquiring at Fix Ya.

Mikeywaf

Posted on Mar 22, 2011

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,866 Answers

Elscomputers

Hello, Thank you for your visit to our expert site.

If you are SURE your cpu fan is in operative order then your motherboard settings in the bios or that actual plug is not putting out the power for that fan to run! You could try another plug on the main board but if you cpu fan's cord has enough length.

Fan is good the main board is not providing power to fan or setting in bios might be off ether or it sounds from your user name that your a company witch I would recommend you to Gigabyte directly due to conflicts of interest!

1. Try a different cpu fan in that motherboard plug to verify that its passing the power. If the new cpu fan does not work then you know its the motherboard.

2. If the new fan spins then it is indeed your cpu fan.

Thanks,

Rulds2008

Posted on Mar 22, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No video and no posting


Your GA-7N400 PRO2 motherboard does not have a built-in video graphics card. You need to install an AGP 8x graphics card into the AGP slot on the motherboard. When you removed the heat-sink & fan assembly the CPU starts to over heat & the CPU will shut down the system. That's why you heard the, european ambulance sound.
If it wouldn’t, you would fry the CPU. Make sure you add thermal grease on to the CPU before re-assembling the heat-sink & fan. Don't forget to plug the CPU fan power connector on to the board.

Motherboard specs;
http://www0.dealtime.com/xPF-Gigabyte-GA-7N400-Pro2
Download & read your manual. Open the link provided here;
http://www.gigabyte.com.tw/Support/Motherboard/Manual_Model.aspx?ProductID=1756

Good luck!
Mike

Aug 12, 2009 | Albatron PX865PE Pro Motherboard

1 Answer

E7400 CPU cooling fan


You need to Plug the Fan to the motherboard. I uploaded an image. http://img140.imageshack.us/i/overviewl.jpg/ Hope this helps

Jul 12, 2009 | Intel Computers & Internet

1 Answer

Wont boot


i think the cpu may have a problem with the board or the memeory. either its bad, damaged or incompartible with your system. try out another cpu

Mar 24, 2009 | Gigabyte GA-K8VT800 Motherboard

1 Answer

No display by gigabyte GA8i915me motherboard


It sounds like your CPU might be overgeating. Check the CPU heatsink fan to see if it is spinning. Also, make sure that you clean out any dust, as this can lead to overheating also.

Jan 23, 2009 | Gigabyte GA-8I915ME-G Motherboard

1 Answer

GA-7VRX Motherboard won't boot


Hi sebaswis, am I correct that this Gigabyte GA-7VRX is a replacement MB? (I read your other posted questions). http://www.fixya.com/support/t1399506-computer_boot_when_power You mentioned you put your old system back together & it worked fine. If mother board is shorted to the system case you will see the CPU fan spin for a second. Most motherboards use a green led which represents there is stand-by power running to the board.(This is normal). I am unsure why your led is orange. (Its not mentioned in your manual & manual does not show the led?s location). Was the other GA-7VRX MB led always orange or was it also green? Suggest you disassemble the heat-sink from the CPU. You mentioned you installed a new XP 2500+ CPU. If a pin on the CPU was bent during installation of CPU into the socket or if no thermal grease was applied or too little to the top of CPU, either would give you: CPU fan spins for a second & nothing else seems to run. Look over the link provided below. It is a guide to how to install a motherboard. (You may not need this but Its worth going over all the steps). http://www.hardwaresecrets.com/article/145 As far as the power supply. If the MB's are the same (GA-7VRX) & the old system ran with 220W, the newer one should also function. Clarify these questions for me sebaswis. Mike

Dec 18, 2008 | Gigabyte GA-7VRX Motherboard

1 Answer

Iv just been given a gigabyte GA-8PE800 motherboard


Gigabyte actually has a very good website. I pasted a link below to the CPU support list.

http://www.gigabyte.com.tw/Support/Motherboard/CPUSupport_Model.aspx?ProductID=1619

As far as what would be the best to buy I would say the closest to the top that you can afford ignoring the P4-Extreme CPUs.

Dec 09, 2008 | Gigabyte GA-8PE800 PRO Motherboard

5 Answers

No Display


you should check vrm section &cmos jumper & ram & cmos battery&bios

Apr 15, 2008 | Gigabyte GA-8IPE1000-G (MBGA81PE1000G)...

1 Answer

Gigabyte mother board


hi reason y it wouldn't start is because the 2 is not compatible, what u can do is get a Intel P4 not a celeronD check the socket size and make sure that it correspond with the board that u have. The board that u have uses a 478 socket size so u need to get a processor with the same socket size ok... that should do the trick

Nov 23, 2007 | Intel Celeron D 330 2.66G CPU...

1 Answer

Fan sound is very high


Check the speed of the fan in the BIOS and set it lower, although 58-63c is alright for a CPU (P4 is rated to go up to 70c) you might want to make sure that you have good air flow in your case to make sure the CPU doesn't overheat. Usually you can find the fan control in the Advanced section of the BIOS. You'll also want to check the specs of the fan that you have installed as that will tell you how loud it's supposed to be. You might have to get another fan with lower decibels if you want it to be quieter.

Apr 06, 2007 | Gigabyte GA-8I865GME-775 Motherboard

Not finding what you are looking for?
Gigabyte GA-8ST667-L Motherboard Logo

Related Topics:

133 people viewed this question

Ask a Question

Usually answered in minutes!

Top Gigabyte Computers & Internet Experts

David
David

Level 3 Expert

778 Answers

Tony

Level 3 Expert

2600 Answers

Matthew Spark
Matthew Spark

Level 3 Expert

1066 Answers

Are you a Gigabyte Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...