Question about Jenn-Air JJW8330D Electric Single Oven

1 Answer

Jenn-aire JJW8530dds The oven door has never closed right. It leaves a gap when closed. Is there a hinge repair or replacement kit? Are there any other ideas on how to fix it? Thanks!

Posted by on

  • cgerbe Sep 23, 2008

    My oven light won't turn off because the door button does not always get compressed all the way. Replaced the cord around the door but I still have to slam the door a couple of times to get the light to turn off.

  • racine1 Dec 25, 2008

    my oven door does not close completely either. The light rarely goes off. Is there a way to tighten the hinges?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

It might be because when the door was completely removed ( which they do rather easily for repairs and moving) it wasn't put back properly.
I would suggest you remove the oven door and re install.
You do not remove any screws or anything like that to remove the oven doors.
When you have the oven door open squeeze each hinge and shift then both outwards it will release the door from the hinge, the hinge stays on but the door will slide off the hindge. Afterwards check the alignment and reinstall the oven door

Posted on Feb 01, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Oven door falls open and will not close tight on my Jenn-air Single oven Model #SVE47100w


Hi,

The hinges and receivers would need to be replaced on this. The hinges are part number 71003351 you need 2, they go inside the door, so the door would need disassembled.

The receivers (hinge receptacles)are part number 71002206 you need 2 also, these go on the side of the oven. You will need to pull the oven out a few inches to gain access to these

Jul 24, 2010 | Jenn-Air Electric Single Oven

1 Answer

We have a 30 in prostyle electric double wall oven - the oven takes forever to preheat and the doors do not seal tightly when they are closed.


Hello- Many ovens use spring-loaded hinges to carry the weight of the door. Over time, these springs weaken or the hinge gets bent just enough to not fully close door. The door gasket can also become flat and stiff, compounding problem. Any small gap releases heated air, and oven will not heat up properly. Replacing the door springs should solve problem.- Thanks -Ed

Mar 14, 2010 | Jenn-Air 30 in. Pro-Style Electric Single...

1 Answer

The oven doors won't close and hot air is blowing out of the lower oven under the bottom of the door


Could be weak door hinge springs, there is no adjustment provided, normally only solution is to replace the door hinges
You may find the following link helpful.



If you find it helps, please leave positive feedback.
Thankyou.

Jan 25, 2010 | Jenn-Air JJW8230D Electric Double Oven

1 Answer

Am negotiating a home inspection on a house with WW30430P Jenn Air Wall Ovens; neither of the doors close. Is there a solution?


There are several models of Jenn-Air ovens that had issues with the door closing. The only solution is to replace the door hinges (unless the doors themselves are bad, you can see this if you open the door, the porcelain on the door will be bulged and cracked right where the hinge joins the door). If the doors are bad, the hinges and the interior door panels need to be replaced. Hope this helps!

Dec 16, 2009 | Jenn-Air WW30430P Stainless Steel Electric...

3 Answers

Oven door does not close fully


You need to replace the oven door hinges.
Please rate my solutrion.
Thanks.

May 15, 2009 | Neff B1421 Electric Single Oven

5 Answers

Jenn-Air electric wall oven door opens slightly when in bake mode


you either have a bent door hinge or a broken door spring.
check the hinges by opening the door and see if it opens past 90 degrees. if it leans towards the floor then the hinges are bent.
if not then your door springs are broken off. you can check this by seeing if the door "feels" heavy when opening.
either way the door should close tight against the frame when up and the light should not come on without opening the door.

Jan 22, 2009 | Jenn-Air 27 in. Electric Single Wall Oven...

1 Answer

Jenn-Air Expressions Mod. W30400BC


no adjustments hinges are mounted inside door panel right?check to make sure theres no damage to inner door panel

Mar 04, 2008 | Jenn-Air JJW8530C Expressions Collection...

4 Answers

Jenn-Air 30 in. Electric Wall Overn jjw8530ddw


lendebr is right...
Same problem here on combo microwave and convection oven. The hinges are a horribly wimpy design. Jenn air has a replacement part thats helps..but the replacment hinges will do the same thing in very short order. 1 month after I fixed ours my sister in law opened the oven door and let go of the door when it was about 2/3 open and that was all it took to tweak the new hinges so the door doesnt close all the way again. i should have clued in when the girl at Jenn air sent me three sets of replacement hinges. I thought it was a mistake..turns out she knew it wasnt going to fix it permanently.
The moral is that Jenn air appliances are POS and I will not ever buy anything from the again..But I will tell everyone I possibly can not to buy anything from them.

Jan 08, 2008 | Jenn-Air 27 in. Electric Single Wall Oven...

3 Answers

Oven door does not close


I had the same problem. The first time the Tech. came out, put a new hinge in and it held until Nov. 07. ( 8 months ). Then the left hinge brakes when I opend the door and it crashes to the floor. Bending the right hinge and the metal doorliner. Jan.7,08 everything was fixed. On 1/11 after no more then 10 openings & closings the hinge broke again. This time I heard the crack of the braking metal after opening the door 2 inches. It now sits in my kitchen propped-up with a stick, waiting for the repairman. I am sorry I have no solution , but there must be a problem with the hinges. I forgot to tell you that it started with a door that did not close, like yours.
Ingrid

Jan 06, 2008 | Jenn-Air JJW8230D Electric Double Oven

1 Answer

The oven door are not closing all the way


spot, Maytag put out a service bullitin on this issue....TDC-0017B-B, They put out a new hinge kit...part #12002111 for single and 12002112 for double units. This may be covered under this service flash. Call Maytag service and inquire about the above mentioned service bullitin. Problem addresses doors not closing...Catriver..post back.

Sep 03, 2006 | Jenn-Air WW30430P Stainless Steel Electric...

Not finding what you are looking for?
Jenn-Air JJW8330D Electric Single Oven Logo

Related Topics:

891 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jenn-Air Ovens Experts

Mike Cairns
Mike Cairns

Level 3 Expert

3053 Answers

 Fix Your Board
Fix Your Board

Level 3 Expert

310 Answers

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Are you a Jenn-Air Oven Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...