Question about LG Televison & Video

3 Answers

LG 32 inch lcd tv. When you turn it on, the screen (no picture) looks like a shattered window. The set is not hooked up to cable, channels aren't set yet. I just bought the tv for my son.

Posted by on

  • jundud Aug 02, 2008

    Thanks very much. Unfortunately I bought it on Craigslist, and the person I bought it from says he never had a problem with the picture--that if it is damaged, it happened transporting it to my house. It wasn't jostled or bumped in the move.

×

3 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 382 Answers

Hello,
As you say this is a new tv,dont worry try to hard reset the tv..Leave it unplugged for 4-5 hours then plug it and use..But make sure you connect it to a cable and set the channels to see if it's really defective..Hope it helps you ...

Kind Regards!!!!....

Posted on Aug 02, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,267 Answers

If the screen looks like that, it could have been damaged during shipping to the store you bought it from.
Try to connect the cable to the TV and see if that shattered window still there. If it is, return the LCD to the store to get a replacement.

Posted on Aug 02, 2008

  • Jaime Hernandez Aug 02, 2008

    Did you see the LCD working before buying it?

    I hope you did not pay a lot for it.

    Did you connect the cable TV to the LCD?

×

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 319 Answers

You need to hook this set up to viewable source to verify if there is a defect.

Then select the source, and check for problems, then.

Is the set used or new?

Brian

Posted on Aug 02, 2008

  • Brian Berndt
    Brian Berndt Aug 02, 2008

    If it is new you should immediatly notify the shipper/retailer.



    Brian

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 55 inch JVC tv,today the screen went black but still have sound, also the buttons on the back wont work, but the channel down button turns it on and off? What is wrong with it?


Fault at its main digital board. Short circuited component/s at it. Contact any service technician; or the authorized service center. If you wish to get some details; check the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/ In most cases, the main board might have to be replaced. If so, a software [firmware] update too might be necessary..

Jan 15, 2017 | JVC Televison & Video

1 Answer

Have a dynex 32 in. and not getting full picture on screen. theres about an inch of black on top and bottom of screen


The TCON board or the LCD panel is faulty. Can confirm by replacing the TCON board .
If you wish to get some details; visit the site linked here. Pull up older posts. http://electro-medical.blogspot.com/

Jan 14, 2017 | Dynex Televison & Video

1 Answer

LG plasma TV. Top half of screen is black. Trying to find out which board needs replaced.


If you wish to get some details; visit the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/ Line faults & possible causes to LCD & Plasma screen are given with illustrations. You can get an idea about the fault to an extent. Faults to all LCD & Plasma screen are similar, irrespective of its brand and screen size.
Search the site by type in the "BRAND NAME" of your device; (Exclude the model number), in the "Search box at the top right of the display window of the Homepage" to get gathered related posts

Jan 12, 2017 | LG Televison & Video

1 Answer

Our LG 55 inch flat screen has sound but no picture.TV is only about 3 years old and this is the first time this has happened.


Check and replace damaged component/s at its back-light inverter board, or replace this board as card basis. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. It will be best to replace the inverter board as card basis. http://electronicshelponline.blogspot.com/ To some model sets; especially LED back-lighted types; the back-light inverter circuit will be part of the main power supply board [SMPS]. In such cases, the power supply board might need replacement. To some models sets, the back-light inverter and SMPS section circuit will be integrated at its main board itself. If so; the main board should be replaced. To some models of sets, all these section circuit will be integrated at its main board. If this is the case, you have to replace the main board.

Jan 12, 2017 | LG Televison & Video

1 Answer

SONY flat screen will turn on green light showing but no picture. TV turns off in 5 seconds. Advice???


Sounds like display panel fault. If you wish to get some details; visit the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/ Line faults & possible causes to LCD & Plasma screen are given with illustrations. You can get an idea about the fault to an extent. Faults to all LCD & Plasma screen are similar, irrespective of its brand and screen size.
Search the site by type in the "BRAND NAME" of your device; (Exclude the model number), in the "Search box at the top right of the display window of the Homepage" to get gathered related posts

Jan 09, 2017 | Sony Televison & Video

1 Answer

My lg plasma tv is cutting off the edges of the shows we are watching. I cant find a setting that will take care of it. Can you help


hmm normally these settings are found in the picture settings of the set top box or just a setting in the tv's picture settings now there might be an option to say fill screen that may work best for some or leave the tv in 16:9 some broadcasts may only be in 4:3 at times this is normal broadcasting and not much can be done unless the setting on the picture option is set to fill screen

Jan 08, 2017 | LG Televison & Video

2 Answers

How do i fix black spots on my LG plasma tv. model 50pj350ub


If you wish to get some details; visit the site linked here. Pull up older posts. http://electronicshelponline.blogspot.com/ Line faults & possible causes to LCD & Plasma screen are given with illustrations. You can get an idea about the fault to an extent. Faults to all LCD & Plasma screen are similar, irrespective of its brand and screen size.
Search the site by type in the "BRAND NAME" of your device; (Exclude the model number), in the "Search box at the top right of the display window of the Homepage" to get gathered related posts

Jan 08, 2017 | LG 50PJ350 50 HDTVReady Plasma TV

3 Answers

LG 26LH2000 television. Last 2 days when I turned my TV on there was only sound, and black screen.


back - light problem. Check and replace damaged component/s at its back-light inverter board, or replace this board as card basis. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts. It will be best to replace the inverter board as card basis. http://electronicshelponline.blogspot.com/ To some model sets; especially LED back-lighted types; the back-light inverter circuit will be part of the main power supply board [SMPS]. In such cases, the power supply board might need replacement. To some models sets, the back-light inverter and SMPS section circuit will be integrated at its main board itself. If so; the main board should be replaced. To some models of sets, all these section circuit will be integrated at its main board. If this is the case, you have to replace the main board.
26359174-wxmxxsggneevie4j1gyznoid-1-0.jpg

Nov 16, 2016 | LG 26LH2000 26 in. HDTV LED TV

1 Answer

I have a 39 inch element tv i cant program the cable channels


Typically you can access the menu, select "tuner" or something similar, make sure you're selected either on CATV or ANT (or similar), then do a channel scan. Should be pretty straightforward. Oh, and make sure you actually HAVE cable. If it's digital cable, you may need an external converter box for it to work.

Feb 23, 2014 | Televison & Video

Not finding what you are looking for?
Televison & Video Logo

Related Topics:

134 people viewed this question

Ask a Question

Usually answered in minutes!

Top LG Televison & Video Experts

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

The Knight
The Knight

Level 3 Expert

69649 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18330 Answers

Are you a LG Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...