It has a red light in stead of o blue it turns on then beebs twice and goes off

Karen-

Are you getting a steady blue light when you follow the pairing procedure? Or are you unable to get it to stay on stead?https://www.motorola.com/moto_care/manuals/BT/H730_QSG.pdf

Mark
Forums Manager

1. Charge the headset:Headset is charged via USB cable, the light will be red when charging. When the battery is fully charged (about 2-3 hours), the red light of the headset will turn off automatically or the red light turns blue.
2. Turn on the headset:Press the on / talk button on the headset for about 5 seconds until the blue and red flashes alternately (or blue flashes or the blue lights all the time ), now the headset is ready to be connected to the iPhone.
3. Go to Settings, and tap Bluetooth. Turn on Bluetooth.
iPhone will automatically start searching for Bluetooth devices. Tap the device in the Devices list, then follow the onscreen instructions to connect to it. After matching successfully, the blue light on the headset will flash twice per time.
4. Call: when you finish all the above steps, you are going to talk via the Bluetooth headset. When there is incoming call, press the on / talk button, you can talk with Bluetooth headset, when you want to end the call, press the on / talk button, you can end the call.
5. Turn off the headset: Press the on / talk button for 5 seconds until the red light of the headset flashes quickly for twice, then release the button, the headset will be turned off.

Hold in the Fn button bottom left hand corner, and press the F11 key. Sometimes need to do this twice to switch on the bluetooth. (icon goes blue)Same to switch it off (icon goes red)

This is known as they yellow light of death(ironic i know). This is caused when the unit overheats causing solder on the board to melt and bridge. Once this happens it shorts out the board causing the error you have now. Contact Sony and see if the unit is still under warranty.

If you have a beebing noise every time you press on the brake, it is because a tail light is burnt out. There are two filaments in each brake light. Therefore, when you turn on your hazards, it will appear that both tail lights work properly. The beebing warning sound is actually a feature that Dodge put in the Rams so drivers would know their tale light is out. Just replace the tail light bulb, and the beebing will automatically cease. To get the tail light housing out, you will need a torex screw driver. Also, you twist the bulb housing out as opposed to pulling it out. There are three prongs that twist out.

could be a memory problem, have seen this before

Kindly remove the battery and sim card from you're handheld and reinstal after few seconds, Even then if it is not working kindly Install BlackBerry Device Software 4.1 version or later.

the blu light means it is accessing a game/ blu ray

go to avs forums - you may have blown capacitors