I need to reverse rotation - Heating & Cooling

You have to reverse the coil (body) from the armature (center). Remove screws of your motor, armature is the center of the motor that rotates. Body is the part that has copper winding in the middle. Reverse this body and screw it back again. Try this and you will find that the armature rotates opposite the way you had it before.

have you got the saw blade on the right direction for cutting
all motors run in the right direction if the blade is on right

There may be a switch on the side of the wiring housing to effect reverse rotation. If the remote does not have a fan reversal button, it can't reverse rotation.

This button simply reverses the action of the feed dogs of the machine. Remove the thread plate and all the mechanism (bobbin, bobbin holder, etc) you can in the bobbin area. This should give you a better view of the operation of the feed dogs. Rotate the machine with the hand wheel to see how it operates. Continue rotating the hand wheel and push the reverse button. See if you can spot what's preventing the feed mechanism from reversing its rotation. Hopefully it's as simple as material or thread buildup in the mechanism.

To reverse the IR model # 8055 , the end opposite of the front-nose , there's an end-cap which can be rotated clockwise/counter-clockwise till it stops ,then afterwards pull trigger switch to energize the tool . This will enable you to change direction of rotation ( all-ways make sure the motor is at complete rest before changing rotation & pulling the trigger back .. Chris

might be the capacitor,you will need a meter that checks MFD. Good Luck Tim

Check the motor wiring diagram, you may be able to reverse the rotation. Usually all it takes is switching wire #5 and wire#8 to reverse rotation.

you can reverse the rotation CCW to CW if you reverse the wiring on the brushes

leads must have gotten reversed. just reverse whichever leads you unhooked to replace the brushes.

If there is not a little switch on the side of the non-rotating part (below the blades) then your fan is not reversible.