Question about Sennheiser CX 300 Consumer Headphones

1 Answer

My left speaker has stopped working and gives no sound most of the time. But if i move the wire a little at the V part, sometimes the speaker works perfectly. Is there an easy way to fix this? I dont have any warranty left.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Sennheiser Master
  • 17,129 Answers

This confirms that the wire is open on the inside and so the only job out for you to to have a close SURGERY to be done to rectify .
You must dissect the wire to see the inside layers, now as you tug the free state of the wire will confirm the position of the wire break. Cut and **** the wire sleeve to see the strands where it has come off, use a good soldering iron to solder after cleaning of the wires. Insulate the joints properly with tight taping and bind them together so that the fault will not recur.

Posted on Mar 19, 2011

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have an old Sony SAVA100 that after a move the left speaker would not turn on giving me no sound. I did a factory reset and now I get sound but only from one speaker. If I hook the RCA (Red and White)...


hi the speaker wire or the plug has become disconnected, this can happen sometimes when moving from one place and moved by vehicle, put the tv down flat on the ground screen side and remove the stand then remove all screws around case. life the back off and on the speaker check it from there to the board, push the connector back on, and with a bit of isolation tape put some over the connector. if it has a female connector to male bend the round parts down with a pair of plyers so its a tight fit to the male connector. refit case in revers order.

Jun 02, 2017 | Sony SA-VA100 System

1 Answer

I have a Sony STR-AV770 receiver that has stopped its output of volume to the left side. Any chance of me fixing this on my own?


your question depends on how good you are at electronic diagnosis (symptom diagnosis) and how adept you are at removing and installing electronc components. first you have to determine why the amplifier has stopped working on the left channel. Make sure that the problem isn't a simple one, take the speakers off the right side and hook them to the left side and see if you get sound. If you do,, then the problem is the left speaker or left speaker wire. If you don't get sound then tyr taking the input that feeds the right channel and pluggin it into the left channel and listen for sound, if you get sound now the problem was the signal from your source not being sent down the left side.
If it still doesn't work you need to move inside the amplfier, but first, get close to the back of the amp and give a sniff, do you smell anything (a pungent burnt wire or rubber smell) if you do, the the chances are good that some components have burned out. Do you recall having a shorted speaker wire on the left side? shorted speaker wires are notorious (especailly older equipment) for burning out the final amplifer stage. If this was an expensive amp it might be worth fixing, if its not worth much then maybe you should consider religating it to use as a monophonic amplifier (one channel) you could use it to power a sub woofer in a hibryd stereo or surround sound system.
I don't know what more I can tell you at this point. If you go through the steps I outlined, and want to tell me the result I shall be glad to respond and maybe give you another direction to head in. good luck and I'm glad you are adventruous enough to want to try.

Mar 20, 2011 | Sony Audio Players & Recorders

1 Answer

Everything on my radio works but theres no sound.i did go into the settings and turn on the power IC


Is that no sound for all speakers and the subs sometimes if just one speaker wire is crossed wrong all the speakers will stop functioning . did you just install it your self or replace any speakers or did it just stop working. i would pull it out and look at the wires mainly the speaker wires and turn the radio on while you can still inspect the connections, wiggle them a little. may help,

Dec 23, 2010 | Car Audio & Video

1 Answer

Front-Right Speaker Not Working


I would have a look inside, it might be a bad soldering joint that got disturbed in the move. When you get inside follow the wires from the Front-Right terminal.

Apr 05, 2010 | Sherwood RVD-8090R Receiver

1 Answer

Left speakers sometimes cut out and leave just a high treble soun


please check the input connecetor could be the losse conact with the wire some times it happens with this type of sound try to play the system and move the connector if the sound trun go replace the input cor

Nov 07, 2009 | Audio Players & Recorders

1 Answer

I sometimes lose sound from my left speaker and it crackles.


this is a speaker input pin problem, like pin is dameg or input pin is not atech proparly in computer problem is still present remove the cable and install new one cable in speaker

Mar 11, 2009 | Audio Players & Recorders

5 Answers

One Speaker Stopped Working


I too had the left speaker malfunctioning. Luckily, i had the curage to open up the speaker and look into the problem. Before that i checked to see if the input inlet to the amp worked by plugging in the right speaker in the left input inlet. I was able to hear the speaker. If you get that response, then the left speaker is the problem. So i went ahead and opened up the speaker. Do this by taking off the fabric cover. There are those little hose plugs you need to take off with a philips head, just wiggle them out. Unscrew the 4 screws. Use a blow dryer around the edges/sides of the face of the speaker to loosen the hot glue holding the cover together. Once the speaker is warm, try prying off the cover. You can maybe use a flat head screw driver to do so but with gentleness or else you'll scratch up the speaker. So once you have that done, look at the terminal(wires that are soddered to the speaker, to check if connected to speaker. if they are not connected, then you would have to soddered them. If everything is intact, then try moving the little plastic piece connected to the speaker, opposite end of that is the possittive and negative wires connected to the cone. I scrapted/moved around the wires being careful not to puncture the cone with the screw driver to check to see if they were making contact with the terminal. I then connected the plug into the amp and fortunately i could hear the speaker once again. I hope this made sense and worked for you. I was glad this worked cuz i truly love the sound of Z-2300 system for the THX certified sound.Sure glad i didn't have to buy another set.

May 20, 2008 | Logitech Z-2300 2.1 Computer Speaker...

3 Answers

Logitech x-230 - left speaker not working when used with 360


my speakers plug into my comp. by that little cord with the green end piece. and i have to figit around with it just to get one speaker to work, can i fix it or do i have to buy the whole set again?

Mar 10, 2008 | Logitech X-230 Computer Speakers

5 Answers

Only one speaker working


Even I have faced the same problem for the past six months.. Today i have fixed only issue with the back jack.. removed slowly and fixed it tightly.. it's works. :)

Oct 06, 2007 | Harman Kardon HK206 Computer Speakers

Not finding what you are looking for?
Sennheiser CX 300 Consumer Headphones Logo

558 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sennheiser Audio Players & Recorders Experts

Vito Vacirca Jr.

Level 2 Expert

140 Answers

Brad Brown

Level 3 Expert

15557 Answers

Gerhardus Stroebel

Level 2 Expert

83 Answers

Are you a Sennheiser Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...