Question about Redfield Revolution Riflescopes

2 Answers

I have a redfield widefield 3 x 9 accu range, from about 1970ish, and would like to use it. however, I don't have the instruction manual that explains how to use it! any idea where one could be obtained??

Posted by on

  • dpola1 Mar 20, 2011

    the solution is no good. the scope is not caliber specfic, and there are no changable disks as would be for a scope with a bullet drop compensator. theanswer is of no help. dale p.

×

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 5,158 Answers

If you would give me the serial number i can try and get you the correct manual that you need

Posted on Mar 20, 2011

×

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,418 Answers

At this time, should a non-Leupold & Stevens, Inc. Redfield product require service, Redfield support suggest contacting Iron Sight, Inc. (918) 445-2001. I can not find a manual for you this morning. Here are some tips on sighting in your scope (generic). Try this sight for more info MILDOT. I will keep looking for you a manual today.


Posted on Mar 19, 2011

  • John Fourteen Six Mar 19, 2011

    Found a bit more info for you on your
    scope and it's use.
    The average whitetail from the top of
    the shoulder to the bottom of the chest should fit exactly inbetween these 2
    lines when the zoom is used correctly. If you notice, the yardage counter in
    the bottom left (4:00 position) it will tell the yardage of the deer when you zoom
    in or out and the torso fills these 2 lines. You may also notice it starts at
    200yds. Thats because you need have your rifle zeroed in at 100 yds. So there's
    no point displaying less than 200 yds. This is where the different dials come
    in. For example: the deer is 300yds away. You zoom in or out until the torso of
    the deer is inbetween the 2 lines then look at the yardage in the 4:00
    position. It should read approx 300yds. Then you dial up to the number 3
    position on the elevation knob and aim as you would if the deer where at
    100ds.




    Look up which dial you need on the ABOUSA site on
    the AccuTrac tables I mentioned earlier. You might be lucky and find the dial
    you have is the right one for your caliber. If not, this company was once the
    offical repair facility for Redfield, Colorado. They may be able to help with a manual and may also have the different
    dials for your scope...at about $10--$30 each.

    Found a bit more info for you on your scope and it's use. The average whitetail from the top of the shoulder to the bottom of the chest should fit exactly inbetween these 2 lines when the zoom is used correctly. If you notice, the yardage counter in the bottom left (4:00 position) it will tell the yardage of the deer when you zoom in or out and the torso fills these 2 lines. You may also notice it starts at 200yds. Thats because you need have your rifle zeroed in at 100 yds. So there's no point displaying less than 200 yds. This is where the different dials come in. For example: the deer is 300yds away. You zoom in or out until the torso of the deer is inbetween the 2 lines then look at the yardage in the 4:00 position. It should read approx 300yds. Then you dial up to the number 3 position on the elevation knob and aim as you would if the deer where at 100ds.

    Look up which dial you need on the ABOUSA site on the AccuTrac tables I mentioned earlier. You might be lucky and find the dial you have is the right one for your caliber. If not, this company was once the offical repair facility for Redfield, Colorado. They may be able to help with a manual and may also have the different dials for your scope...at about $10--$30 each.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Opperating instructions


have you checked online by chance ???

Aug 30, 2014 | Redfield Counterstrike Red-Dot Sight

1 Answer

Where can I get a manual for a Redfield 6-18x accu trac scope?


Dear Carl,

I have the same problem and have not been successful finding an actual manual. However, if you go to "abousainc.com" there is a link for general instructions. It is under "Redfield Scopes" and then scroll down to "How to use the AccuTrac." However, it does not give the starting point of the instructions and only gives the table for the different dials. I will try to explain what those 2 lines at the top of the reticle are for.

The average whitetail from the top of the shoulder to the bottom of the chest should fit exactly inbetween these 2 lines when the zoom is used correctly. If you notice, the yardage counter in the bottom left (4:00 position) it will tell the yardage of the deer when you zoom in or out and the torso fills these 2 lines. You may also notice it starts at 200yds. Thats because you need have your rifle zeroed in at 100 yds. So there's no point displaying less than 200 yds. This is where the different dials come in. For example: the deer is 300yds away. You zoom in or out until the torso of the deer is inbetween the 2 lines then look at the yardage in the 4:00 position. It should read approx 300yds. Then you dial up to the number 3 position on the elevation knob and aim as you would if the deer where at 100ds.

Look up which dial you need on the ABOUSA site on the AccuTrac tables I mentioned earlier. You might be lucky and find the dial you have is the right one for your caliber. If not, this company was once the offical repair facility for Redfield, Colorado. They also have the different dials for sale but are quite expensive...$10--$30 each.

Hope this helps,
Mark

Jan 16, 2011 | Redfield Revolution Riflescopes

2 Answers

Why does my 30 yr old redfield, widefield ,range finder accu-trac scope that has operated great for all these yrs, now I cain,t get it hit in the same zone a target. The rifle is clean and operates great...


well if the bullet hit is jumping about its all down to your scope,,,it could be that its just "lose on its mount!" or its died on you,,like the cross hair is bouncing about inside the scope so with the recoial it jumps into a new place with every shot fired there by giving you a new point of impact,,,
this can happen if the scope was wound right up or down or left or right and strain was put on the adjusters,,,you may need to buy a new scope,,,,a good "air rifle!" scope will work quite well on most full bore rifles,,,yer right i here you say!!! ok,,iv got air rifle scope's on my .303 + 7.62 + 22-250 + .357 under leaver marlin cowboy, all 3 of my .22 rim fire's and they have been on these rifles for years now,,,1000,000, of rounds fired so far, with no problems! and no drifting so far,,,
an air rifle scope is very strong you know,,,but they only cost £150,00p or less for a good one?????
ps,,,,dont buy a tesco scope there cra*y

Nov 22, 2010 | Redfield Optics

1 Answer

I need to know how to use a redfield 6x-18x accu-range scope that was made in the 60s


Check here:
http://www.abousainc.com/ATsystem.htm
This may help.
DonB

Apr 29, 2010 | Optics

1 Answer

Looking for a redfield 3x9x wideview accu-trac rifle scope manual or instructions


This may help you:
http://www.abousainc.com/ATsystem.htm
Nice sope!
DonB

Dec 30, 2009 | Redfield Optics

1 Answer

Need basic usage instructions for accu range and accu trac i.e. what do the horizontal lines that are located at the top of the reticle do or symbolize or represent.


http://stevespages.com/zip/united_states_army_fm_23-10%20-%2017_august_1994.zip

in order to get basics you need to know how to run the optic, i suggest you download this and read it, and start practicing. or find the users manual on your scope to figure how to work your elevation, windage, and rectify paralax.

Dec 06, 2009 | Redfield Optics

1 Answer

I need to adjust the focus of my Redfield widefield scope, by focusing the ret field scope does it change the accuracy of the optics?


no it dont,,, it makes it even more accurate,, how can you see clearly if its out of focuse,,,,,

Nov 17, 2009 | Optics

1 Answer

I NEED TO IDENTIFY A SCOPE.IT IS A REDFIELD WITH OVAL EYEPIECE AND ROUND FRONT.IT HAS A DIAL ON TOP THAT SAYS UP WITH AN ARROW.IT IS 12.75 INCHES LONG.ALSO HAS A DIAL ON EYEPIECE END THAT GOES FROM 3 TO...


The best guess I can make using my books going back to 1970. Cant be sure of the dates they started, but about 1980 Redfield made what they called, Widefield low profile scopes. They made 7 of these Widefield scopes, 3 Variable power wide view and 2 they called Accu-trac Varable these 2 are in 2x-7x power and 3x-9x power the Accu-trac scope is the one you have I believe.

Nov 16, 2009 | Optics

1 Answer

I have a Redfield 3x9 widefield scope that I love but now will not hold zero


check all mounts to make sure they are tight and scope wont turn or slide if all is ok get a new scope

Oct 28, 2009 | Optics

1 Answer

Can a novice install a Redfield base and rings?


Problem solved. Redfield had all the size information I needed and mounting the base was a breeze.

Jan 17, 2009 | Redfield See Thru Rifle Scope Mount Base...

Not finding what you are looking for?
Redfield Revolution Riflescopes Logo

Related Topics:

776 people viewed this question

Ask a Question

Usually answered in minutes!

Top Redfield Optics Experts

Joe Lalumia aka...
Joe Lalumia aka...

Level 3 Expert

3186 Answers

kakima

Level 3 Expert

102366 Answers

Mark Campeau

Level 1 Expert

44 Answers

Are you a Redfield Optic Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...