I had a new pump put in as my old one was making a noise and wouldnt shut off, but the water was ok , with the new one i get a bit of water or none at all, should i put back my old pump

check pressure switch

make sure that the pulleys of all the driven equipment are in alignment and not at a bit of an angle to the axis of the drive belt
To break belts something is not lined up properly or something is not turning freely

Either the water pump is bad or the power steering pump or the tensioner or maybe the tension on the belt is insufficient. If you have air conditioning, the bearing could be bad in that but that's a bit remote.

1. Step 1 Drain the antifreeze from cooling system. Remove belt from water pump. Examine and see if you have to remove anything else to get out the water pump. If so make a diagram of everything you are removing so you can put it back together.
   
2. Step 2 Remove the hoses from the water pump. Find all bolts holding the water pump in . Loosen each one a little bit. After all are lose you can then remove them. Remove water pump. Put new gasket on and install new water pump. Hook up hoses to water pump. Look at your diagram and replace everything you had to remove earlier. Put the belt back on.
   
3. Step 3 Shut the drain on system and refill cooling system. Make sure you use the antifreeze that is designed for system. Run engine for a couple of minutes. Check for leaks and check coolant level. Add if necessary. If there is no leaks you are ready to go.
   

The tension pulley on the Ford products is famous for wearing out. If you are positive about where the noise is coming from, then the only real solution is to purchase a new pulley from the dealership. Installation involves removing tension from the serpentine belt, unbolting the old pulley and installing the new one. Put the serpentine belt back in place and you are done. I have tried in the past to lubricate those pulleys both on and off the car - it never worked for any length of time. Seems like once the bearing is worn to the point of making noise there is no saving it. Let me know if this helps you out or not.

These cars sometimes have dead shorts in the radios. Have an expert check this out for you.

Check the AC compressor pulley, it is the one that useually freezes up

hope phone has not had any water in it. try software update via usb cable and nokia pcsuite

buy a new water pump, remove the radiator, remove the hose from the pump, remove the bolts that holds the pump, remove the old pump.

put the new gasket in the pump, dont forget to put a little bit of grease just to hold the gasket inplace. put the new pump, use the old bolts from where they are taken ( sometimes they are not of equal length ). if you have a torque wrench then use it to tighten the bolts with equal amounts of torque. put the hose back, put the radiator back, put water in the radiator, run the engine and look for some leaks at the new pump.

i hope i did it..

tnx, drcool

indesit idl 40 not pumping water out properly, ends with flashing light no 4 and plates dry but water still in machine -have to pump out using start stop button but within 2 hours base filled up with water. Can't afford massive call out prices as lady on my own.....