Question about HP DesignJet 1050c InkJet Printer
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: The HP Designjet 1055cm has
I doubt it. When the printer powers up, it checks to make sure that all modules are in place and functional. If one is missing, you'll get an error message.
Posted on Dec 10, 2008
Please read through some of the information provided in this link and this link from the HP support forums.
Also see this basic troubleshooting guide here.
I hope this information allows you to resolve this issue. If you need further assistance, please post back with a comment to this thread.
If I've managed to answer your question or solve a problem, please take just a moment to rate this post....thanks!
Posted on May 20, 2009
that error show a problem with the pintheads
Remove ALL the Printheads and clean the flex contacts on the
Printheads and in the Carriage Assembly, if that dont solve the problem change printheads, if after that have the same problem call HP, was a hardware error.
Posted on Aug 27, 2009
System Error: 0C0032 (Continuable)
Drop Detector not Calibrated for all Printheads.
Corrective Action: Try the following:
n Perform the Service Station Calibration þ
n Replace the Drop Detector Assembly þ
n If the Error Code continues, replace the Electronics Module þ
WARNING Only replace one component at a time and check if the error has
gone before replacing another component. Using this procedure
you will be able to determine exactly which component failed
this is a continuable error.
Posted on Nov 30, 2009
Hi there only can try.
This is a firmware error, meaning your f/w simm is probably bad. You can try reseating the simm. It is behind the small panel in the back of the plotter, that is held on by 4 torq screws. Reseat all the simms that are present and see if that helps. If not, you probably need to purchase a new firmware simm.
Also try looking at
pulling the JetDirect card and then re booting it
Posted on Feb 10, 2010
Tips for a great answer:
Dec 26, 2012 | HP DesignJet 1050c plus InkJet Printer
Dec 29, 2010 | HP DesignJet 1050c InkJet Printer
Mar 19, 2010 | HP Office Equipment & Supplies
Jan 29, 2010 | HP DesignJet 1050c InkJet Printer
Jan 11, 2010 | HP DesignJet 1050c InkJet Printer
Nov 03, 2009 | HP DesignJet 1050c InkJet Printer
Sep 25, 2009 | HP DesignJet 1050c InkJet Printer
Jun 29, 2009 | HP DesignJet 1050c InkJet Printer
May 20, 2009 | HP DesignJet 1050c InkJet Printer
Apr 30, 2009 | HP DesignJet 1050c plus InkJet Printer
68 people viewed this question
Usually answered in minutes!