Question about JVC Projection Televisions

Open Question

JVC Model HD-61Z456 No Picture and Power and Lamp light are blinking at same time fast!

Posted by on

6 Suggested Answers

SOURCE: JVC HD-527575 problem

We just had the same problem. The Projector lamp is burned out. You can get the lamp at Electrified.com. Their phone # is 800-678-8585

Posted on Oct 22, 2008

  • 1 Answer

SOURCE: jvc tv

when both the blue light and red light are blinking it means 1 of 3 things. 1. lamp replacement. This often works everytime for the repair. TIP!!! DO NOT USE ANY OTHER LAMPS OTHER THAN JVC AUTHENTIC LAMPS. ANY OTHERS AND YOU RISK DAMAGING YOUR TV FURTHER. 2. the fans are not working properly or need to be replaced. They need to be cleaned every so often and they will stop working from burn-out if not done so. This repair will cost you less than 100 dollars. 3. The ballasts are defective and need to be replaced. The ballasts themselves run about 150 dollars. I tell you I have fixed this TV more times than I care to count, not to mention the number of lamps I have gone through. The guy at the TV repair place now knows me by name when i come to buy lamps. :(

Posted on Dec 07, 2008

  • 25 Answers

SOURCE: jvc hd -61z456

These guys are correct, you need a new dlp lamp. The lamp # for your particular television model is the TS CL110UAA.

Posted on Apr 16, 2009

  • 1779 Answers

SOURCE: JVC HD-61Z456 Television to dark

Most likely a bad Polarizer within the light engine of which you cannot buy. The entire light engine would have to be re-built or replaced and they usually start around $600.00....

Posted on Jul 09, 2009

  • 1 Answer

SOURCE: Lamp and Power lights blinking fast and no picture...

hi mach500..We just had the same problem. Did you find out if it could be the fan?
Thanks

Posted on Aug 28, 2009

fieldy14
  • 456 Answers

SOURCE: rapid blinking light (lamp) on a JVC model HD

It normally means the lamp is in need of being replaced, and its all depending on the use of the TV as well as how long the lamp life is. You should be able to access the lamp via a small section near the rear or the back of the TV unit, if the lamp is blown or faulty it will look the same as a blown light globe.
To obtain a new lamp contact the brands authorised repair agent as they will be able to get trade prices and in turn, give you the best price,
Also make sure that whoever replaces the lamp resets the lamp use time as the TV will still not start if you don't reset the lamp use time as it will still think it has a faulty lamp. I hope this helps, good luck.

Posted on Dec 05, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The lamp light and power light (the red and blue lights) are blinking together but no picture. What can I do


The tv projection lamp has been inside tv about 2 years alredy?Yes.Time to replaced the tv projection lamp.The tv projection lamp life are over.

Jun 15, 2011 | JVC HD-61Z456 Television

1 Answer

How do I change the lamp in my my JVC HD 61Z456 television


On the link below page 78/79 will tell you how to replace the lamp.

http://books.jvc.com/Download/642587931/LCT1928-001A-A.pdf

Good Luck and please rate 4 thumbs up for the free answer

Sep 30, 2010 | JVC HD-61Z456 Television

1 Answer

My jvc model #hd-61z456 is working at too dark of a picture. I have replaced the light bulb twice and have reset the picture setting to factory setting and I don't know what else to do can you help me....


Both times bulbs was replaced it lasted 1 1/2 or 2 years right?Use tv on like 4 or 5 hours a day?That the avervage life span of a projection bulb.Try to buy an original JVC pojection bulb last little longer.

Sep 12, 2010 | JVC HD-61Z456 Television

1 Answer

JVC HD-61Z456 Television to dark


Most likely a bad Polarizer within the light engine of which you cannot buy. The entire light engine would have to be re-built or replaced and they usually start around $600.00....

Jul 09, 2009 | JVC HD-61Z456 Television

1 Answer

JVC HD-527575 problem


We just had the same problem. The Projector lamp is burned out. You can get the lamp at Electrified.com. Their phone # is 800-678-8585

Oct 10, 2008 | JVC HD-52G786 52" Rear Projection HDTV

2 Answers

NO PICTURE OR SOUND


Hi
Usually, if the red light is flashing and you get no picture, that means that the lamp life cycle is finished and you'll have to get a replacment lamp. the lamp has about 3000 hours of life (2 to 3 years under nomal use).

You can buy a replacment lamp from here
http://cgi.ebay.com/NEW-DLP-LAMP-BULB-JVC-FOR-HD-61G787-HD-61G887-HD-61Z456_W0QQitemZ320274762989QQcmdZViewItem?IMSfp=TL0807151554r7572

Hope this helps
Cheers

Aug 10, 2008 | JVC HD-61Z456 Television

3 Answers

Jvc hd -61z456


These guys are correct, you need a new dlp lamp. The lamp # for your particular television model is the TS CL110UAA.

Apr 21, 2008 | JVC HD-61Z786 61" Rear Projection HDTV

Not finding what you are looking for?
Projection Televisions Logo

Related Topics:

82 people viewed this question

Ask a Question

Usually answered in minutes!

Top JVC Projection Televisions Experts

easy alberta
easy alberta

Level 2 Expert

132 Answers

Jaime Hernandez

Level 3 Expert

2267 Answers

The Knight
The Knight

Level 3 Expert

68301 Answers

Are you a JVC Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...