Years ago I purchased a Kinkead Vista-Pivot Shower Door, model 1500-31, Silver. For a variety of reasons the shower didn't get built until recently. However the door opening is now 32.5 inches wide so it would appear that the existing top and bottom rails are to short. Can longer top and bottom rails be purchase to make the door fit? Or is the door itself not wide enough to fit in this opening? Thanks for your help, John

have a look here it should guide you in the right direction: Sterling Plumbing Service Parts
Vista Pivot II Shower Door Height 65 1 2 Max Opening 36

I have the same issue how do you replace it without removing the entire frame

Try looking at shower door suppliers, and glass companies that make shower doors.

go back to where u GOT it.

HOMEDEPOT

sterling is an inexpensive kohler product,....go to a plumbing supply store with your #s and they'll be able to get what you need.

call 800-sterling they can send u out a new set or any other questions u have sterling is a kolher company

Sterling has a video on their website that explained what I needed.

on the pivot side, the seal will go toward the outside,.providing that the seal is on the door,...the seal "on the pivot side of the door" will go up against the wall jamb as you close door,.....

instructions for shower door installations are very important to have,..i have installed over 100 of them and i still wouldn't attempt one without instructions,.your totally best to do the research it takes to get the instructions needed for this job,...there are certain cuts and measurements that are very dependent on specifications given by manufacturer to be right,....one wrong cut domino effects the whole job,....good luck