Question about RCA HD52W59 HDTV Projection Television

1 Answer

CHANNEL CHANGES BY ITSELF

MY TELEVISION WILL TURN ON/OFF BY ITSELF AND WHEN IT IS ON, THE CHANNEL KEEP CHANGING.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 520 Answers

The remote may be malfunctioning. Take the batteries out of the remote and see if the problem stops.

Posted on Aug 02, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

RCA P56950 Powers on then 10 mins later powers off, repeats cycle. Then channel display in TV changes by itself


may be some thing is stuct on the controt pannel power button or others check. try this it may work

Jun 04, 2012 | RCA P56950 56" Rear Projection Television

1 Answer

My model p52960 will not hold a channel just keeps changing


Your TV is haunted !

j/k Perhaps your remote is all wet underneath the buttons, you can remove the batteries from the remote to remove this as a possibility, If the tv comes on still and changes channels still, then you know its not the remote. You may also have defective batteries leaking acid all over the place in there. If it is the remote, you can unscrew and open up your remote and clean the circuit board button landing pads with rubbing alcohol and clean the other side of the rubber conductive pads that touch the landing pad area from the back of the button itself.

Hope for the best and Good luck

Christopher

May 15, 2012 | RCA P52926 52" Rear Projection Television

1 Answer

RCA Projection P52937SG Continually changes channels and wont respond to controller


This is an older set but I have two questions:

Is the set actually changing channels up or down or are the number for the channel doing that while set remains on same channel?

Two possible problems, some of these also had the Guide Plus Logo on the front of the set.

If I know which issue you have I can help.

SD TECH

Oct 25, 2011 | RCA P52937 52" Rear Projection Television

1 Answer

RCAP46924 turns on by itself then constantly changes channels . Remote will not work.


Check for a sticky channel up or down button on the TV.
That will cause that problem.
Hope this helps.

Nov 14, 2010 | RCA P46924 46" Rear Projection Television

1 Answer

I have no front control panel working and changes channels


The front controls are called Tac Switches. They have a tendency of becoming corroded and sending erroneous commands to the micro. You can disconnect the lead coming from the control panel to the chassis and see if it quits. If it does, that answers your question. If you decide to replace them all, try Encompassparts.com

Jul 15, 2009 | RCA P52937 52" Rear Projection Television

1 Answer

Magnavox PJTV model 51mp392/17 -pressing channel buttons changes


You need a professional.
Your TV has "lost is mind"

Stop using the TV until it is repaired.
Continue to use it and your problems will multiply and grow more expensive.
Call the manufacturer to find you nearest authorized service center.

MR. TV Sales & Service Inc
Milwaukee Wisconsin 53405
(414) 762-8600
Established 1974

Mar 24, 2009 | Philips Magnavox 51MP392H Rear Projection...

1 Answer

RCA P52939 turns on and off by itself


the front buttons are common for going flaky - if you remove the front grill you should be able to unplug them and use the remote only
if you use the buttons let me know and i will look up the board or switch part # all switchs will need to be replaced
thanks
scott

Jul 14, 2008 | RCA P52939 52" Rear Projection Television

1 Answer

My tv changes channel by it self


I have the same problem, anyone with a solution

Oct 25, 2007 | RCA P52926 52" Rear Projection Television

1 Answer

Television picture gets larger


Your problem most likely is in your high voltage circuit, and the 160 volt radial lead capacitor is probably gone high ESR or changed in capacitence, this usually happens during bright sceens or sceen change.

May 24, 2007 | Panasonic PT-51HX40 51" Rear Projection...

Not finding what you are looking for?
RCA HD52W59 HDTV Projection Television Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top RCA Projection Televisions Experts

The Wyzzyrd

Level 2 Expert

83 Answers

D. E. Hev

Level 3 Expert

1059 Answers

Ron Dufek
Ron Dufek

Level 3 Expert

398 Answers

Are you a RCA Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...