Question about HP PSC 1610 All-In-One InkJet Printer

1 Answer

HP 1610 will not power up !

I have the HP 1610 All In One printer/fax. This morning I pressed the "On" button and it remained off, ie. no power. I checked plug and transformer unit and plugged it into a different receptacle... still no power. I also used my voltmeter and tested out put of transformer and it showed 16v DC... no problem there.
So, is there an internal fuse or reset button somewhere? If no, is there a where can I get a schematic?
Thanks,
Britt

Posted by on

  • 1 more comment 
  • Jen 37 Oct 07, 2008

    Have the same problem?!!!!!!!!!!!!!!!!!! Help!!!!!!!!!!!!!

  • Anonymous Oct 13, 2008

    Have the same problem, please help me!

  • Anonymous Dec 03, 2008

    same thing.

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 27 Answers

Hii...
i mean your printer logic board damage.need to change new logic board..ac burn.no way to change the part..need to change whole board coz it not seprate..

Posted on Nov 18, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The message prints out from my HP Officejet 7410: A communication error occurred during the transmission. Result Error 232* It was working fine before, now it won't fax 2 pages.


Actually Error 232 is mostly because of the Remote machine still we can try one thing in your machine ie - we can disable Error correction mode

How to disable it?


1. Press the or > button until the front display reads "Fax Setup".

2. Press the ENTER/MENU button.

3. Press the or > button until the front display reads "All Faxes".

4. Press the ENTER/MENU button.

5. Press the or > button until the front display reads "Error Correction".

6. Press the ENTER/MENU button.

7. Press the button until the font display reads "Off" and then press the ENTER/MENU button to save the setting. (Off disables ECM and On enables ECM).

Try to send fax now .. It should work

Please Vote for me if it works

Jan 04, 2011 | HP OfficeJet 7410 All-In-One InkJet...

1 Answer

A sheet of paper had remain in the cylinder


  1. Remove the rear cleanout from the printer.
  2. Gently remove any jammed paper or bits of paper.
  3. Close the HP Paper Feed Cleaning Kit software on the computer.
  4. Load plain paper in the printer paper tray.
  5. Press the Power button to turn the printer off.
  6. Press the Power button to turn the printer on.
  7. Try printing again. If the printer still does not pick up paper or if a paper jam occurs again, service the printer.


Other solutions customers found helpful » HP Paper Feed Cleaning Kit -- Clean the Paper Feed Rollers with the HP Paper Feed Cleaning Kit in Windows XP and 2000 » HP Deskjet, Photosmart, and PSC All-in-Ones -- 'Out of Paper' Error Message and the Printer Does Not Pick Up or Feed Paper » HP PSC 1600 and 2350 All-in-One Series Printers -- 'Paper jam: Press OK to continue' Message Displays on the All-in-One

Dec 15, 2010 | HP PSC 1610 All-In-One InkJet Printer

1 Answer

Does hp 1610 priner scanner have a fax capability?


I'm Sorry to say that PSC 1610 has no fax feature

P-Print
S-Scan
C-Copy

Regards
Riztech

Sep 27, 2010 | HP PSC 1610 All-In-One InkJet Printer

1 Answer

Printer


SolutionFollow the steps below to resolve the issue. Step one: Wait for the current task to complete
  1. This message appears while the unit performs a task. If a task was aborted while in progress, this message will remain on the display.
  2. Press Cancel or Stop to clear the message.
  3. If the error does not go away, proceed to the next step.
Step two: Reset the unit
  1. While the unit is on, remove the power cord from the rear of the unit AND the wall outlet.
  2. After one minute, reconnect the power cord to the wall outlet and the unit.
  3. If the unit does not turn on, press the On button.
  4. If the error does not go away, proceed to the next step
    If this doesn´t work, release all cartridges, and turn on. After that put the cartridge on the printer one by one. Regards.

Apr 05, 2010 | HP PSC 1610 All-In-One InkJet Printer

1 Answer

HP PSC 1610 All-In-One will not shut off. Even with on/off button.


I believe you have to press and hold the power button on these machines.. If this does not work, I would replace it.

May 25, 2009 | HP PSC 1610 All-In-One InkJet Printer

1 Answer

My hp psc 1610 printer will not print


1. Click the Start icon, click Control Panel, click Printers and faxes folder.
2. Right Click on the printer icon and Select Properties.
3. In Ports tab of the properties window, check the box beside "Enable bi-directional support".
4. Click OK to confirm the changes.

Feb 20, 2009 | HP PSC 1610 All-In-One InkJet Printer

1 Answer

Remove and check right cartridge (black ink)


I have discovered how to perform a full reset of the HP PSC 1610, which clears all the internal memory, thereby fixing the "remove and check right cartridge" problem.
To perform a full reset of the HP PSC 1610:
1. Unplug the power cord.
2. Press and hold the OK and CANCEL buttons on the front panel keypad.
3. While still holding the buttons, plug the power cord back in. Continue to hold the buttons for two seconds, and then release them.
4. After a few seconds, the screen will display the message “Deriv Clear” confirming that the reset is done.



I have discovered that the HP PSC 1610 all-in-one printer has a hidden diagnostic mode, which lets you do several interesting things.

To enter the hidden diagnostic mode of the HP PSC 1610: 
1. tap both arrow keys simultaneously.
2. tap the left arrow key.
3. tap the OK key.
4. At this point, you have a choice to make. If you want to enter the "Service" menu, tap the left arrow key. If, on the other hand, you want to get into the "Underware" menu, tap the right arrow key.

There is a menu option in the "Underware" menu called "printer-mech button tap", from which you can initiate any of HP's "tap tests," so called because, on the early HP printers whose onboard user interface was limited to two physical buttons, you would tell the printer which diagnostic test you wanted it to perform by holding down one of the buttons while tapping the other button a certain number of times. In the HP literature, the various diagnostic tests that the printer can do are named according to the number of button taps required to initiate the test. Hence, HP might refer to "tap test #6", "tap test #9", and so forth.
I am not sure what all of the various tap tests do, but I would imagine there is probably a tap test that resets the internal counter responsible for making the printer reject the cartridges.

Dec 25, 2008 | HP PSC 1610 All-In-One InkJet Printer

2 Answers

Meter read on HP Laser Jet P2015


To print a Configuration page from the printer, press
and hold the Go button for 5 seconds

May 16, 2008 | HP LaserJet P2015dn Printer

3 Answers

CARTRIDGE WONT ALIGN


The following error message appears on the LCD panel1.gif on top of the printer after you insert a cartridge: Press enter to align cartridges . You press Enter , but the error message does not go away. The printer will not print. Solution To bypass the cartridge alignment, do the following:
  1. Press and hold the Setup button.
  2. Press the Options button. The printer should be ready to print.
If the print quality is unacceptable after bypassing alignment, follow the steps below until the error is corrected.

Feb 13, 2008 | HP PSC 2210 All-In-One InkJet Printer

Not finding what you are looking for?
HP PSC 1610 All-In-One InkJet Printer Logo

Related Topics:

205 people viewed this question

Ask a Question

Usually answered in minutes!

Top HP Printers & Copiers Experts

kakima

Level 3 Expert

96518 Answers

k24674

Level 3 Expert

7987 Answers

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

Are you a HP Printer and Copier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...