There really no problem I just need to know how to change the date and time on the Xerox FaxCentre F12 machine.

I am sorry to tell you but it appears that Windows 7 does not support this machine.

No drivers are found available on Xerox website. "see below link"

http://download.support.xerox.com/pub/drivers/Compatibility_Matrix/other/win7/en/Windows7_Matrix.pdf

None of the Fax Center printers are compatible.

Again i am sorry

You don't really need to block incoming faxes, but just set the machine not to automatically answer them. This figure is from the manual:



Press the MODE button until you see MANUAL displayed. In manual mode you need to answer and start receiving a fax yourself from the machine.

You can download a copy of the user manual from Xerox if you need it.

One needs to know what they are doing when resetting memory to the machine.
When resetting the machine, one needs to consider, the loss of memory data on the copy cartridge counter in the machine.
When resetting memory a copy toner cartridge needs to be in stock with a counter reset card.
Erasing memory will wipe out the old copy/toner cartridge odometer setting, resuling in "Replace toner/cartridge" error.
Please clarify which memory area is being erased.

Often times with that machine, if you replace the drum before it says replace, it will not reset.

Find the menu key, scroll through the items to setup.
Scroll to date and time.Use the side arrows to make your selections.

There is a fuse in the power supply, That is located under the paper catch tray.Just look to the right of the on off switch, You will see 2 silver phillips screws in that cover. Remove those and pop the cover off, it will POP, there is a tab holding it in place, so it will have alittle resistance in removing it.
You also will have to remove 3 screws on the power supply shield to access the power supply. some have 1 some have 2 fuses. If the supply is bad. Google a business called " the parts drop". Give Britt a call, he is very good to deal with and will have that part.

Did you ever figure this one out? I'm having the same issue

You will have to perform a memory clear . Here are the steps, but after doing this you will have to re enter the fax ID and phone number, also you will have to reset the power save mode to where ever it is now.
Here ya go.
The Clear System Data Memory option restores all the user-selectable options to the factory defaults.

1. Press the [Menu / Exit] button on the Control Panel.
2. Press the [Up] or [Down] arrow button repeatedly to select [Memory Clear].
3. Press the [Enter] button.
4. Press the [Left] or [Right] arrow button to select [Machine Setup].
5. Press the [Enter] button.
6. Press the [Left] or [Right] arrow button to select the required option: [Yes] or [No].
7. Press the [Enter] button.
8. Press the [Menu / Exit] button to return to the previous menu.
9. Press the [Stop / Clear] button to return to the Standby mode.

1. Instead of printing / copying page by page, collate the print...see the options while printing...it will look like 111,222,333 OR 123,123,123 etc.,

2. connect the machine to LAN network by using the LAN module
3. if LAN module is not available, connect a PC to it directly and make it the print controller -> share the printer -> install drivers in other pcs and ..... start printing


have a nice day

bye

I hope my solution was useful

There are a couple of fuses in that power supply. But if it is a 412 or an F12 most likely you have developed cracks in the solder connections of that particular LVPS.
I would recommend replacing the LVPS.
Roughly a 250 dollar price on that power supply.