Question about iRobot Roomba Discovery SE Bagless Robotic Vacuum

2 Answers

Press the power button on - good got a green light (new battery) press the clean button - got a green light iRobot runs for a couple of seconds and stops, then starts, then stops. After two or three times I now have a red light on for the Status. All of the wheels seem to be clean. I used compressed air to clean the underside. But still have the start stop problem.

Posted by on

  • jdf_ferguson Mar 13, 2011

    The robot seems to have the power and the power light stays green the entire time but it starts and runs a short time, stops then starts again. Even after removing the battery.

  • jdf_ferguson Mar 17, 2011

    the robot comes on, whirls around a couple of times and stops, I restart and the robot whirls around a couple of times and stops. this time around on the third restart it tried to whirl but stopped and the red light (status light) comes on and will not restart.

×

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,299 Answers

How many times does the red light blink before it pauses?

Posted on Mar 14, 2011

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 2,382 Answers

Hi, remove the battery and hold the power button for 15 seconds. This will restart the charging cycle as if the battery were new. If after 72 hours, it stays orange your battery is either sub-standard voltage or not sold as advertised.

Posted on Mar 13, 2011

  • Tunde Autos
    Tunde Autos Mar 14, 2011

    Hi, you can try the diagnostic test on this LINK......

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Amber flashing light while on home base. New, pulled tab, placed on dock. First time said charge err1, took out battery and replaced. Now just flashes amber. Is this correct?


Your manuals are here. Flashing lights must be covered. A quick look at the site says flashing red is bin full. In fact, I found it. Flashing Amber is CHARGING.

Roomba 600/500 Battery and Charging Overview On some robots, the CLEAN light should pulse red/amber while charging. ... Amber - partially discharged; Red - nearly discharged; Flashing Red - discharged . homesupport.irobot.com homesupport.irobot.com/.../roomba-600%2F500-battery-and-charging- overview LabeledSupport ... clipped from Google - 12/2015 iRobot: Customer Care - Roomba 700 Anatomy homesupport.irobot.com homesupport.irobot.com/app/answers/.../a.../roomba-700-anatomy images?q=tbn:and9gcss8oogw3vmcv_uom0z_pxoi9q5tq9n4aqrcwbsxn0zd1blfvnacictdbyn iRobot: Customer Care - Roomba 700 Anatomy Solid Red = Battery Discharged; Amber Pulse = Charging; Solid Green = Fully Charged; Quick ... The battery indicator blinks when there is a charging issue. homesupport.irobot.com homesupport.irobot.com/app/answers/.../a.../roomba-700-anatomy LabeledSupport ... clipped from Google - 12/2015 iRobot Roomba 500 Series Battery Maintenance homesupport.irobot.com homesupport.irobot.com/ci/documents/.../042809_500MaintBatt_vib iRobot Roomba 500 Series Battery Maintenance Roombas "CLEAN" light should pulse red/amber while charging. ... Green - fully charged; Amber - partially discharged; Red - nearly discharged; Flashing Red - ... homesupport.irobot.com homesupport.irobot.com/ci/documents/.../042809_500MaintBatt_vib LabeledSupport ... clipped from Google - 12/2015 Roomba 400 Series/Discovery Battery and Charging Overview homesupport.irobot.com homesupport.irobot.com/.../roomba-400-series%2Fdiscovery-battery-and- charging-overview Roomba 400 Series/Discovery Battery and Charging Overview Your Roomba's POWER light should pulse red/amber while charging. ... Amber - partially discharged; Red - nearly discharged; Flashing Red - discharged. homesupport.irobot.com homesupport.irobot.com/.../roomba-400-series%2Fdiscovery-battery-and- charging-overview LabeledSupport ...

iRobot Owner Manuals and Quick Start Guides

Dec 31, 2015 | Roomba Vacuums

1 Answer

Roomba 560 fully charges. Runs for 2 seconds fully green and just stops. And lights up red.????


Set him on the floor, after powering him off and then back on, and press the "Clean" button three times. This will reset him.

Sep 11, 2014 | iRobot Roomba 560 Robotic Vacuum

1 Answer

My irobot (Roomba)is only working for 10 mins then


It should take about 6 hrs to charge. I had the same problem and reset the charging circuit. 1) Charge it until the green light comes on. 2) Unplug and pull battery out. 3) hold down the power on button 15-30 seconds. 4.) Put the battery back in, plug in the charger (direct - not through the dock) and charge for 72 hrs. Then, run at Max clean until the "I'm dead" tune plays.

May 12, 2010 | iRobot 4150 Roomba Vacuum

1 Answer

I think the battery is not holding its charge anymore. The red (charging) light does change to green but only runs a few yards on leaving the dock.


You have dead nimh (nickle metal hydride) batteries2_bing.gif.
You will need a replacement. You can test for this by removing the battery and holding the power button for 15 seconds. This will restart the charging cycle as if the battery were new.

Mar 04, 2010 | iRobot Roomba 560 Robotic Vacuum

1 Answer

The green light is on as though the battery is fully charged, however, when I start a cleaning cycle, it beeps and goes to red immediately without moving.


Remove the battery, hold down the POWER button for ten seconds, then put the battery back in and charge overnight. If it still tells you it's out of power as soon as you start it, it's time for a new battery. http://store.irobot.com

Aug 23, 2009 | iRobot Roomba 4210 Bagless Robotic Vacuum

1 Answer

My iRobot scooba won't turn on after a full charge


Do you have the charger terminal, or do you have the charger that you have to take out the battery and charge. Because I have found that my base terminal charger works better than the battery charger that needs the battery to be removed to charge.If you have the terminal charger and the power light is green when it is in the charger I would start from the terminal

Jul 26, 2009 | iRobot 5800 Scooba Vacuum

1 Answer

Scooba battery light turns red as soon as irobot starts


Do you leave the battery on charge long enough? Try 4-hours up to overnight. If so, then the battery is probably at the end of it's useful life. Getting a new battery depends on cost versus life expectancy of the robot and whether it does the job you want it to do.

Jul 19, 2009 | iRobot Roomba 4210 Bagless Robotic Vacuum

4 Answers

Scooba now stops sooner and isn't finished cleaning :-(


I had this problem and contacted irobot. An important fact was left out of the early edition user manual to not leave the battery charging for an extended amount of time. Because of this ommision, they sent me a new battery and a software upgrade for the scooba. I just followed the directions and attached the little device they sent to do the upgrade the scooba and it fixed the battery problem.

Hope this helps.

Jul 17, 2009 | iRobot 5800 Scooba Vacuum

1 Answer

Roomba cuts off after a minute or so.


If you have a 400 series Roomba, try removing the battery, then holding down the power button for ten seconds, then recharging the unit before you run it again.

If you have a 500 series Roomba, don't take out the battery-- just press and hold the "spot" and "dock" buttons for about fifteen seconds. The Roomba will play a tune, and you can then charge it and try running it again later.

May 13, 2009 | iRobot 4150 Roomba Vacuum

Not finding what you are looking for?
iRobot Roomba Discovery SE Bagless Robotic Vacuum Logo

Related Topics:

217 people viewed this question

Ask a Question

Usually answered in minutes!

Top iRobot Vacuums Experts

Brad Brown

Level 3 Expert

15941 Answers

Shehu Pro
Shehu Pro

Level 3 Expert

1284 Answers

The Knight
The Knight

Level 3 Expert

74377 Answers

Are you an iRobot Vacuum Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...