Question about Eltax Thunder 10 Subwoofer

1 Answer

I had my eltax thunder 10 for a few months and it was working fine then one day I turned it on and there was no sound. There is still power as the green light comes on and im sure it hasnt blown as when I play with the input cable it makes some thudding noises. Are there any common problems I should check? thanks for any help!

Posted by on

  • steffan_07_f Mar 13, 2011

    I have tried a new cable and it just does the same thing.

×

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 8,546 Answers

Is there something preventing you from trying a new cable? You're touching the problem when you wiggle it.

Posted on Mar 13, 2011

  • steffan_07_f Mar 13, 2011

    I have tried a new cable and it just does the same thing.

  • David Dunn
    David Dunn Mar 13, 2011

    If the wiggle still has an effect, follow it. Only YOU can observe what is happening. Perhaps the connector inside the speaker is defective or has a bad solder joint.

×

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Television


Yes. Sounds like the power supply is shot. However that being said do not be suprised if after changing the power supply you find that the main board is gone out as well. Take the cost of that board as well into consideration before repairing. My insignia did the same thing and parts alone were more than the set was new...fortunately mine was under warranty.

Aug 09, 2016 | Vizio Televison & Video

1 Answer

1995 sl1


replace ignition coil

Jun 20, 2013 | Saturn Cars & Trucks

1 Answer

Hi there was a pop and burning smell from the box. I guess its bust but hope it can be repaired as I cant find a replacement anywhere.


Unfortunately it does sounds like there has been a system overload. Your speaker is an active system meaning it has its own power unit inside. Somewhere in the internal amplifier there has been a circuit burned. I have copied the link to the contact page for the stereo repair search website. If you will do a search for your state information, this site will locate a repair service near you.

http://www.stereorepair.com/

Oct 31, 2010 | Eltax Thunder 10 Subwoofer

1 Answer

Sylvania LC320SS8 32 in. LCD Television - Will not turn on


U have power on 10 mins,than is not the power supply board.Ur Tuner board is dead replaced that board.Tries websites Shopjimmy.com,Ebay.com to buy a refurbish tuner signal board.

Feb 09, 2010 | Sylvania LC320SS8 32 in. LCD Television

1 Answer

Loud boom when going in standby mode.


i would check your sub connection also make sure the volume isnt set to high. sometimes unplugging the power and cables also helps

May 20, 2009 | Eltax Atomic A-8.2 Subwoofer

1 Answer

Eltax avr-200 no sound


Eltax AVR-200 will start up in protection mode if the amplifer went into protection mode due to high volume before it was turned OFF and it will start at the same volume level as it had before power OFF.

To correct this you must shift to another input without signal, then turn the volume down before it goes into protection mode again.

Jan 12, 2008 | Audio Players & Recorders

1 Answer

I can't hear any speech when I play a DVD, but I have all other sound.


Yes what you heard is correct,look for center speaker connection.If it is correct then connect it thru coaxel or digital out and see.

Feb 09, 2007 | Eltax DV-100 DVD Player

Not finding what you are looking for?
Eltax Thunder 10 Subwoofer Logo

Related Topics:

264 people viewed this question

Ask a Question

Usually answered in minutes!

Top Eltax Audio Players & Recorders Experts

kakima

Level 3 Expert

102366 Answers

 Grubhead
Grubhead

Level 3 Expert

5113 Answers

The Knight
The Knight

Level 3 Expert

74185 Answers

Are you an Eltax Audio Player and Recorder Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...