Screen reads sab & none of the functions work

Skip,

The fact that the display is 'ON' confirms you have power.

The displayed info probably is a 'code' for a fault/problem, but you did not provide a brand nor a model. Even if you had, odds are I do not have access to the list of codes & their meanings.

Try unplugging the plug from the wall receptacle. If you cannot reach the power cord next option would be locate the circuit breaker (single pole) which HOPEFULLY is labeled. Either way, try removing / turning OFF power for at least 10-20 seconds! The control's microprocessor may be locked up due to a very short power interruption.

If that does not reset it, I would call service or the manufacture. You can TRY requesting help over the phone FIRST! Good LUCK

Mrs. Robin Adair-Weber, CET

If sab Push and hold clock button in for a few seconds.When it clears, the oven should work fine. God-Bless! Just let me know if that works. It is in sabbath mode. Research said it is sab not sa6,

FB2 SAB is a 'cement' type resistor.
The value is 560 ohms.
The power rating is 3 watts.

This is the Sabbath feature on my Kenmore Elite Electric Slide in Range. My oven manual says to press both the (timed oven) "cook time" button and the "delay start" button at the same time for approx. 3 seconds and this should shut down the feature. I had the same problem, tried the above and it worked.

amana oven reads SAb or 5Ab code? stove works, oven doesnt??? HELP

Hi.


The beeping sound is a warning because the oven is in lock condition. The oven is not faulty, and the code is not 5AB, but SAB.

SAB means that the oven is in Sabbath mode, and the control board will be locked for 72 hours with SAB on display.

If power is disconnected a new 72 hours cycle will start.

Push and hold the Clock button for about 10 seconds, that will reset SAB mode.

If that does not work leave the oven connected and off for 72 hours. If the oven does not unlock after three days, then the electronic control may be stuck in SAB mode because it is faulty, in that case contact the manufacturer at the number listed on the owners manual.

Regards.

try pressing and holding the clock tab on the erc for 5 secs
this will usually cause the sab to flash 3-4 times and then retrun to normal operation mode

SAb flashing and then displayed continuously.
• Oven is in Sabbath Mode. To cancel, press and hold the
Clock pad for five seconds.
•

ok danish mein ne aap ki problen parkh le hai sab se pehle app apne moblie mein band setting cheak karein. aur ise try band par kar len.ya phir apne cell ki setting restore kar dein agar masnla hal na ho to phir dobara poch le zaror ,thanx

same exact thing happened to me! Its not reading *5Ab* it's reading "Sab" as in Sab MODE...PRESS AND HOLD THE CLOCK BUTTON FOR A TOTAL OF 4 LONG SECONDS!! AND WAAAM!! Your stove is fixed and back to normal..with the Time! lol