Question about Casio Watches
If you look at the circuit board above the text there should be two contacts. Use something to short them "tweezers". After that it should reset and work again.
Posted on Aug 01, 2008
it is a tricky way but it can be done...
remove the clockworks completely (that's including the plastic casing) from
separate the plastic frame from the clock
remove the little screw you spoke about earlier
look at the edges of the big battery clip holder, they latch to the clock
housing at three locations,
pry-off the cover plate...Presto battery can be removed. Before you
reassemble in reverse order make sure that the pushbuttons in the housing
can move freely, lube with light oil if necessay or remove them completely
to remove sweat and dirth
Posted on Aug 01, 2008
Tips for a great answer:
Choose a quiet, well-lit room where you can replace the battery in your Casio Pathfinder watch. Prepare a table, desk or other clean, flat surface where you can perform your watch repair. Put down a soft cloth or piece of craft felt to protect the face of your Casio Pathfinder watch from being scratched during the battery installation process.
Set your Casio Pathfinder watch face-down on the soft cloth or craft felt. Use an optical-sized Philips screwdriver to remove the four screws that secure the watch back to the body of the watch. Set the screws aside, but don't lift the watch back.
Slide the watch back off of the body of the watch very slowly. There are three important springs held underneath the watch back; it is essential to remove the watch back slowly to avoid losing them.
Lift the three springs out of your Casio Pathfinder watch using a small pair of metal tweezers. Take note of the length and placement of the springs as you remove them. Set the springs aside with the other disassembled watch components.
Take the black rubber protective disk out of your Casio Pathfinder to reveal an identically-shaped white plastic disk. Remove the white plastic disk and set it and the black rubber disk aside. Use your metal tweezers, if necessary, to lift out the rubber and plastic disks.
Release the battery strap that holds the battery in place in your Casio Pathfinder watch by pushing the battery strap latch to the left. Remove the old battery from your Casio Pathfinder using a pair of small plastic tweezers.
Pick up your replacement watch battery with the small plastic tweezers and insert it into the battery compartment of your Casio Pathfinder watch. Replace the battery strap and push it gently with the tip of your plastic tweezers to snap the latch in place.
Touch the "-" and "AC" terminals on your Casio Pathfinder watch with the tips of your metal tweezers for at least two seconds. This helps ensure that your watch will work properly once reassembled.
Put your Casio Pathfinder back together to complete the new battery installation. Start by replacing the white plastic disk, followed by the protective black rubber disk. Use your small metal tweezers to replace the small watch springs in their correct locations. Replace the back cover of your Casio Pathfinder, insert the four screws and tighten them with your optical-sized Philips screwdriver.
Sep 19, 2010 | Casio Pathfinder PAG40B-2V wristwatch
Sep 14, 2010 | Casio Wave Ceptor WV57HA-1AV Wrist Watch
Apr 08, 2010 | Casio Protrek Triple Sensor Tough Solar...
Jul 06, 2009 | Casio E-DataBank DBCW1501 Wrist Watch
Feb 10, 2009 | Casio Twincept Databank ABX238BV Wrist...
Dec 15, 2008 | Casio G-Shock GW500A-1V Wrist Watch
Aug 14, 2008 | Casio F91W-1 Wrist Watch
Jul 11, 2008 | Casio Watches
Mar 24, 2008 | Casio G-Shock GW300CA-1V Wrist Watch
Feb 24, 2008 | Casio Sea-Pathfinder SPF40-1V Wrist Watch
Nov 27, 2016 | Casio Watches
265 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: