Ridgid r250af18 finish nailer operator's manual, part # 987000592 missing. I would like another manual.

This problem occurs when check band is not in place. Remove the head and pull out the cylinder. There should be a rubber band around a series of holes on the cylinder. Replace if broken or just put back in place. Good luck

Manual can be found at the address below. Enter your model number in the search box. Good luck with your nailer.

https://www.gardnerinc.com/manuals/


I found manual at the above address for my ridgid full round head nailer.

check rigid's website or use google

The hammer is jammed so take a punch and a hammer and hit the end of the nail to punch it back where it ented

http://www.ridgid.com/Tools/Support/?warrantyMenu=%23&warrantyMenu=%23&criteria=nailer&selectType=

Go to the Ridgid webpage on your gun at: http://www.ridgid.com/Tools/R250AFA-Nailer/ You can downloak an owners manual or parts list in PDF format. Just click on the little icons under the model number. The files are fairly big so, depending on your connection speed, they do take a little while to download.

when pressed down the main switch is activated, so switch could be faulty or connections loose

I assume you have a R250AF18. The operator's manual for this nailer is here. There's an exploded diagram with a parts list here.

Could be a couple problems. A soft click sounds an awful lot like electric motor failure, but given that it's 6 moths old, this is a warranty issue. Rigid has a 3 year limited warranty on this tool. You can check here for a service center near you or give them a call at 866-539-1710 and they'll take care of you. Ridgid's customer support is generally very good.

A manual for your nailer can be found here:
http://www.ridgid.com/Tools/Support/?warrantyMenu=%23&warrantyMenu=%23&criteria=r250afa&selectType=

Good luck.

insert a open fitting adapter into the connection end and make sure you are getting a good air flow with open ended connector hold away from face and eyes while doing test and be sure the fitting is well seated into coupler before releasing . let me know result