Question about PC Desktops

1 Answer

WE need the AC adapter for a KDS monitor - PC Desktops

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Filmmaker:

    Uploaded 5 video answers.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 97 Answers

Monitors don't have a/c adapters...they just plug into the wall....they use a standard grounded pc plug. you can see for yourself by unplugging your pc and using that plug into your monitor. it should fit. good luck

Posted on Jul 31, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dell front panel power light abcd lights yellow


Does the monitor go out completely, no power? Or just lose a signal? Check ALL cables, AC and Monitor cables. Could be a Graphics adapter issue or Monitor , try another monitor.Your computer has a few miles on it , right? You could buy a PCI Graphics card if the monitor is OK.

Jan 01, 2013 | Dell Dimension 2400 PC Desktop

1 Answer

Hello, i broke the screen on my laptop wanting to switch it to my desktop monitor but for some reason it wont switch over. unfortunately since i cant see the screen i cant get into my startup menu any...


First, disconnect the laptop from the ac adapter and take off the battery and the memory. Press the reset button on your laptop. Connect your ac adapter only and press the power button two or three time while everything else is disconnected. Then, re-install your memory and your battery. Connect the ac adapter to the laptop and to your power source. Now turn on your laptop and see if you get a display on your laptop screen. If you do, then you have reset everything and you are back to where you started. Good luck and let me know how it goes.

Dec 06, 2010 | PC Desktops

1 Answer

3 beep sound


If a PC suddenly fails to boot properly, you should perform a hard reset as the first action. Performing the hard reset will correct many problems. If the computer still does not start properly, select your symptom from the list below to guide you to the recommended corrective actions.
  1. Disconnect all peripheral devices and remove all USB devices and SD media cards. You want to test the computer not the accessories!
  2. Disconnect the AC power adapter, remove the battery, and then press and hold the power button for at least 15 seconds to drain all residual power and restore default startup settings.
  3. Reconnect the AC power adapter (but do not insert the battery), Press the Power button, Look for glowing LEDs near caps lock and num lock keys, and Listen for sounds of a fan or other moving parts turning.
  4. If the computer does not start, the LED lights do not glow, and the display is black, you can perform one or more of the following actions to resolve the no power issue.
    • Verify the computer is receiving power from the AC adapter . Verify that the AC adapter is not damaged and is connected correctly to a working wall outlet plug. Verify AC power is connected to the system board by examining the AC adapter, wiring, and pin connection for damage. The keyboard LEDs will glow when AC power is connected to the system board. Damaged components, like the AC adapter or the pin in the power connector, may require an HP-certified repair.
    • Use a different AC power adapter . If you have access to a different AC adapter or power pack that is designed for the computer, connect it to the notebook and try to start the computer. If you own or have access to more than one notebook, verify that you are using the adapter which belongs to the notebook. CAUTION: Using a power adapter that does not meet the power requirements or has the wrong type of connector may damage the computer. On newer notebook models, connecting the wrong adapter to the notebook may cause the power LED lights to blink but not power the computer.
    • Remove the battery and boot on AC power only . A discharged or defective battery may prevent the AC adapter from supplying enough power to start the computer. To verify that power from the AC adapter is available for PC; remove the battery, connect AC power adapter, and press power button. If available, try using a different AC adapter, that is rated for the PC, and repeat this test.
    • Remove the AC adapter and boot on battery power only . A defective AC adapter may not charge the battery and prevent the computer from booting on battery power only. To verify battery power available for the PC; connect AC power adapter, allow battery to charge for 30 minutes or more, disconnect the power adapter and press power button. If available, try using a fully charged battery, of the same type, from another computer and repeat this test.
      • If LEDS do not glow and the fan or hard drive do not spin, battery may need to be replaced.
      • If tests of both the battery and the AC adapter fail, there may be a problem with system board requiring service by HP.
      • If LEDs glow and PC boots, the AC adapter may need to be replaced.
      • If LEDs glow, but PC does not boot go to LEDs glow, fan is heard, but display is black or blank section.

Nov 21, 2010 | HP Compaq d530c PC Desktop

1 Answer

I have a toshiba satelite p2050-57802 laptop and im trying to figure out how to hook up monitor to laptop. Screeen got broken on laptop and misplaced manual. Can you help please ?


There is a monitor connection on the back of the pc, next to the ac adapter connector. Just plug in your monitor to it and make sure you plug the monitor's power cord into an electrical wall outlet.

Oct 06, 2010 | PC Desktops

1 Answer

I am looking for an ac adapter for a Max Displays monitor


You may get it from your nearby shop of electronics or from the place from where u bought the device
if u are not getting that model from shops than u may buy i t from internet
thanks

May 15, 2010 | PC Desktops

1 Answer

The problem is with the monitor on my used by my wife, connected to her PCU. Tonight as she was using it, the monitor, a Acer AL1913b LCD Monitor, flat screen, went black. My computer, across the room...


Hi,
There is only one way to check it out.... or to find out that where is the problem 
in monitor or in cpu......
Solu: Plug another monitor to your cpu... if the other monitor works that men problem in your monitor else problem is with the cpu....

Good Luck!!
Please do rating...
Thanks for using FixYa.

Mar 25, 2009 | PC Desktops

1 Answer

I can turn my laptop on but the screen is black


Hi,


Do you hear a beeping sound when turning it on? Try connecting an external monitor (Desktop monitor) then press FN+F8 (Dell laptop only) and FN+F4 (HP laptop only). If it works on an external monitor, you may need to contact your computer manufacturer. check the warranty and request for an LCD monitor replacement.

If you hear a beeping sound when turning on your laptop or no power (no light). you may need to reseat the memory (RAM) or check the AC adapter (power adapter).

Let me also know the system model and computer manufacturer.

Keep me posted.

Thanks.

Oct 18, 2008 | Acer PC Desktops

1 Answer

The AC adapter that I brought from Best Buy doesn't have enough power to get my computer to- charger-up. The S/N of my computer is T3A6931000974. The tec from best buy said that the adapter didnt have...


Looks like a 90 watt AC adapter will do what you need

http://www.batteryfuel.com/ac-5001sp-gateway-mx6955-laptops-90w-universal-notebook-ac-adapter.html

Sep 05, 2008 | Gateway PC Desktops

Not finding what you are looking for?
PC Desktops Logo

Related Topics:

25 people viewed this question

Ask a Question

Usually answered in minutes!

Top PC Desktops Experts

joecoolvette
joecoolvette

Level 3 Expert

5660 Answers

Brian Sullivan
Brian Sullivan

Level 3 Expert

27725 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18297 Answers

Are you a PC Desktop Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...