Question about Whirlpool Ultimate Care II LSQ9549L Top Load Washer

1 Answer

No power we have washed a duvet and suspect that this caused a problem.the next wash didn't complete and the next wash began the agitator befoer the water was in.now there is no power at all it seems dead checked the usual plugs socket etc no luck.any suggestions please.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 943 Answers

THanks for the question I think the lid switch is your problem .The washer will fill , but nothing else check that its located under the top

Posted on Sep 11, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a F21 error, there is a duvet inside in mid-cycle. I suspect it was too big. Can I solve this problem myself and how?


did you remove your drain filter and clean it, if this gets clogged it can cause a slow drain and result in a f21 error code

Apr 28, 2015 | Washing Machines

1 Answer

Can i wash a duvet?


Most duvets can be washed in the washing machine without any problems. If you are just looking to "freshen up" the duvet, you can use the steam/refresh option on your washer for 15-20 minutes. If you'd like to wash it, place it in the washer with similar items (other sheets, pillow cases, etc) and follow the wash instructions on the manufacturer's label. Most can be washed with the normal cycle (cold water).

Dec 27, 2011 | Whirlpool Duet 4.0 Cu. Ft. Steam Washer

1 Answer

Can I load a duvet?


It could be a problem depending on your drum size. Ive usually found a single duvet will fit but if you have to push the door firmly to close it i'd be tempted to go to the launderette with it.

Dec 04, 2011 | Indesit Washing Machines

1 Answer

Sometimes it spins sometimes it doesn't had a problem this morning with a king size quilt, it came out soaking so I tried to spin it again & its still wet, I put in another load & then it...


Duvets/quilts are very heavy when wet, causing a very unbalanced load. If the machine could spin such a large uncentred (UK spelling!) mass it would shake itself to pieces, so all modern domestic washing machines have unbalanced load detection systems. In use these systems will vary the drum rotation to try and get the load evenly distributed before going into full spin, but if they can't then no spin occurs.

Very few domestic washing machines can take a duvet or quilt (certainly no front loader which I'm aware of, and only a few top loaders), and those which can fit them in are usually overloaded. There's nothing wrong with your machine, you just need to use a commercial launderette machine to wash and spin your duvet/quilts in future.

Feb 16, 2011 | Washing Machines

1 Answer

I have a Kenmore top loading large capacity washer model 1028882791. It began washing as usual then began to making a loud humming sound. The agitation stopped. It only makes a loud humming sound. I...


The humming sound is coming from the drive motor running but unable to drive the agitator nor the basket to spin. The drive motor is definitely running as the drain function works because of the fact that drain pump is directly coupled with the rear spline of the motor. The drain pump works in either direction as long as the motor runs. The problem is obviously a broken motor coupler which transfers the mechanical energy of the motor to the transmission. The solution then is to replace the broken coupler. Click on the link below for the detailed step-by-step procedure in replacing the motor coupler.

Replacing Motor Coupler on Kenmore and Whirlpool Top-Load Washing Machines

Jan 13, 2011 | Kenmore Washing Machines

1 Answer

Load was placed into the washing machine. the


There are many causes for your problem. The cover switch may not sense that the cover is closed. The timer may not be working properly. There could be a burned out motor or wire broken. If it sounds like it is running but not then it could be a broken or slipping drive belt. I suggest that you get a repairman to check it out and repair it.

Oct 08, 2009 | Kenmore Washing Machines

1 Answer

Whirlpool - Agitator stopped,help?


Hi, This machine has no belt. Tip the washer back and see if there is any black or white rubber dust laying on the floor. How long ago did this accur? Has the motor has time to cool down so that you can try it again?
Let me know if I can assist you further.
Thaks
Vic

May 14, 2009 | Whirlpool Ultimate Care II LSQ9549L Top...

1 Answer

Slow spinning agitator with knocking sound


agitator dogs. take them out and replace.

Feb 28, 2009 | Whirlpool Washing Machines

1 Answer

Removing agitator


Sometimes small articles of clothing can manage to get between the inner spin basket and outer wash tub. This is NOT common, however. If this were the case the memory stick you mentioned, would end up lodged in the drain pump. There would be a noticeable noise from the impeller hitting it and it may cause the pump to fail, resulting in drainage problems. More than likely, its right where you suspect it is. To remove the agitator, do the following:

1. Remove the center cap or dispenser from the agitator.
2. Under the cap or dispenser is another plastic cap with a pull handle on it. Lift this cap out by pulling straight up, exposing the agitator mounting bolt.
3. Loosen the agitator bolt using a socket and ratchet. Once removed, grasp the entire agitator assembly by the bottom flanges and lift straight up. The entire agitator should come out.

NOTE: When reinstalling the agitator make sure you DO NOT overtighten the mounting bolt or it can cause damage to the agitator and restrict the movement. Good and "snug" is the rule of thumb.

Searspartsdirect.com has an excellent exploded view diagram of your agitator and components if you need a good reference. Just type in your COMPLETE model number and look under the "Agitator, Basket and Tub Parts" heading.

I hope you find what you're looking for and hope this helps you in some way. If you require additional assistance, please let me know.

Sep 26, 2008 | Whirlpool Ultimate Care II LSQ9549L Top...

Not finding what you are looking for?
Whirlpool Ultimate Care II LSQ9549L Top Load Washer Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Whirlpool Washing Machines Experts

Dan Webster
Dan Webster

Level 3 Expert

8147 Answers

Richard Roth
Richard Roth

Level 3 Expert

9472 Answers

Mike Cairns
Mike Cairns

Level 3 Expert

3053 Answers

Are you a Whirlpool Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...