I want to know the cost of BM board of WEGA Projection TV

Bulb has died. Google tv
Model and "lamp replacent". Will cost you about $90usd. 1 screw on side of rear right of tv.. Lift and pull replace.

Check the picture below to find the G board on your TV.

Tv have a problems known as a convergence problems,it dead.The tv convergence board require it 2 STK convergence ICS and some or all it resistors are dead,require changing.These parts on the tv convergence board,must have to replaced these parts to solved convergence problems.The shop will cost u $300-350 for parts and labors.

Could be lamp, driver bd., or both. Probably $250 for driver replacement.

hello http://lmgtfy.com/?q=projection+tv+replacement+lamps they cost about 195 brand new, off ebay 100 quid

regards
shaun

Hi,
Below image shows H4 Board (temp sensor) position in TV.
Let me know if you need part number of H4 board.
Hope this will help you.
Thanks.

I have over 10 years experience in electronic tech support.

I know this isn't what you want to hear, but the problem you've described sounds like one of the circuit boards that control the picture quality needs to be replaced. The cost of the board would likely be in excess of $200. There are usually several boards in a TV like that that control the picture and when one goes, you can get anything from lines in the picture to poor picture quality from blurriness. The main question is do you want to spend $1000 to fix a used TV?

I hope I've provided you useful assistance and that this information allows you to make an informed decision as to how to proceed from here. Please be sure to vote on my response. I hope I've earned a good rating from you today.

Please let me know if I can be of further assistance.

HAVE YOU CHECKED YOUR PROJECTION LAMP TO SEE IF ITS BLOWN ?

Hello mccueke,
This is what i know for a fact worked. This will not cost you more than 0.99 at the store.


Best regards
circuitcity

Hello izitme,
You may posted it in the wrong forum, But since you are already here....How much do you want for the darn thing? Where are you located?

Thanks
Circuitcity