Question about Hotpoint Aquarius WD63 Front Load Washer/Dryer

1 Answer

Drier Motor The Drier is not blowing. the top of the washer heats up . the clothes get hot but no drying

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 254 Answers

Disconnect the vent at the back of the dryer and dry a load unvented to make sure you don't have a clog in the vent line too the outside causing an air flow restriction, if still not drying check and make sure the blower wheel that circulates the heat inside the dryer isn't broken.

Posted on Jul 30, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Electrolux troubleshooting


Very hot says heater is okay perhaps the fan is not operating due to cut out.... this fan blows air which is then heated and dries the clothes,if its a condenser drier then check also the water valve is opening and pump operating...

Nov 01, 2013 | Washing Machines

1 Answer

Drier dries too slowly. it does heat up but i always have to turn on again for 40 more minutes to complete drying. it does get hot. and i am not overloading.


You do not state if you are using a machine with an automatic drying sensor. If so the calibration of the sensor is off. Try setting the control to a dryer setting. If you are using it by time only, it would appear there may be a blockage in the air outlet. Check the damper flapper at the output of the air vent. It might be partially stuck closed thus reducing the air flow around the clothes. Just a thought that your washer spin dry may not be sufficiently spin drying the clothes and so that the clothes are overly wet when put into the dryer..

Oct 05, 2011 | Estate TEDS840JQ Electric Dryer

1 Answer

My dryer is giving off outside heat and not drying my clothes


check the filter is clear and the access vent from heater fan to tumbler is not blocked - have seen a sock blocking air flow -
drier is only a fan blowing air over a heated element & through a duct or pipe into the tumbler - on exit the air passes a filter and if this is blocked - through passage is obstructed and hot air will escape backwards

May 26, 2010 | Whirlpool Dryers

2 Answers

My Neff drier isnt drying my washing it is hot but the


Is the fan working? this blows air across the element which in turn cools the steam into water then pumps it out via pump,Hope this is of some help

Apr 13, 2010 | Neff V4380X0 Front Load Washer / Dryer

1 Answer

CDB115


should be a reset switch on the back of the machine usually just a red button or small hole if not there is over heating protection on the heating element or elements if it has 2 heat settings ,but these cannot be reset have to be renewed

Oct 05, 2008 | Candy CNW156 Front Load Washer / Dryer

1 Answer

DRYER STOPS


could be thermal overload in motor its a motor protector in the motor when the motor gets hot it cuts power to the motor when motor cools it closes and resets age of drier counts some times you can take drier apart and blow dust out of motor and will fix now if the door is not closing tight vibration can cause door switch to break contact that will do it too most of time motor or relay must be replaced

Oct 27, 2007 | Kenmore 63942 Dryer

2 Answers

Neff washer/drier


soap drawer is just a slide fit - give it a good yank. for the dryer, take the top off and there should be a mainifold across the top with stats mounted on it. one or two may be re-settable stats ie have a little button in the middle which press to reset. if this works, cause of stat popping out is usually a lint blockage in the dryer manifold

Apr 28, 2007 | Neff V4380X0 Front Load Washer / Dryer

2 Answers

Maytag Neptune W/D (Stacked) Drying Irregularly


Mj, 90% of the time long dry times are caused by a pinched or clogged vent. Other things that could be causing this are: cycling thermostat trips too soon, if your dryer is a gas model, weak gas valve coils, drive motor centrifugal switch not allowing voltage to the gas valve or heating element. Check the harness to the motor to make sure it is on tight. Catriver...post back.

Sep 25, 2006 | Maytag Neptune MLE2000A Front Load Stacked...

Not finding what you are looking for?
Hotpoint Aquarius WD63 Front Load Washer/Dryer Logo

Related Topics:

110 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hotpoint Washing Machines Experts

hungoverrr

Level 1 Expert

5 Answers

puggy666

Level 1 Expert

47 Answers

freddyfox

Level 2 Expert

236 Answers

Are you a Hotpoint Washing Machine Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...