I have a Pioneer DEH-P2000. How do I program the channels?

l


Pioneer DEH P2000 Manuals

you can seek to a station you like and then choose a preset button 1-6 . press the chosen preset button for a few seconds until the display blinks. the station should then be locked into that preset.

you probably have a bad switch. it is probably best replaced by a professional.

depending on how many channels the amp is, you may not be able to hook everything up to it.

usually you have a separate amp for subs. 4 channel amp for the speakers in the car, and a mono amp for the subs.

To hook them all up to the same amp you would need an amp with 5 channels. It wouldn't work out right.

If you have a mono amp its only for subs.

If you have a 2 channel you can either hook it up to the rear speakers or bridge them to mono to run the subs.


you need a channel per speaker basically.

turn radio off and press clock then press function for about 4 seconds and the display will appear with the clock functions

Pioneer follows the universal after-market color code, so if your CD player was made in the last ten years or so, the wires should go like this:

Yellow: Constant +12VDC (memory)
Red: key-switched +12VDC (accessory)
Black: Ground
Blue/white: amp remote or power antenna output

Speaker wires: The solid-color wire of each pair is positive; the black-striped wire is negative.

Left front: white
Right front: gray
Left rear: green
Right rear: violet

Hope this helps!

Try Pioneer's website, I've downloaded similar info before.

I’m happy to assist further over the phone at https://www.6ya.com/expert/robert_aad3edb7dfa380b9

Scroll to the station then press and hold the preset button you want it to goto.

Scroll to the station then press and hold the preset button.

The solution for setting the radio station on a Pioneer DEH P2000, is to tune the station you want programmed and hold down the desided channel number until the program number appears on the display.
BC