How do i put the belt on a frigidaire gallery front load washer

it almost has to be the belt think the front comes off to check it out

Good afternoon friend, that's a great question!

I understand that you are trying to replace the selector knob on your Frigidaire washer, GLTF2940E. Normally this is not a DIY job and we would recommend having a technician come out to the home in order to properly disassemble your front panel and replace the selector knob as needed. Hope this is helpful. -Matt

Hello - Typically error code 59 indicates that that washer is not detecting a tacho signal for three seconds. Contact a professional to move forward accurately. Technician will need to remove the belt from the motor, spin the motor pulley and diagnose the speed control board.

Is the motor buzzing or is it buzzing at the console?

its ether the transmission or the motor gone bad

sounds like the belt that goes around the drum has come off the pulley or belt has broken you should be able to look under it to see the belt is on or off. hope this helps you.

For general advice on cleaning a washer lint filter, try http://www.ehow.com/how_2083872_clean-washing-machine-lint-trap.html

check the belt make sure it is still contected.
if that is good you may have a faulty door lock

the belt is broken.or the motor is out on the barrel.need a repairman

I have a stacking Frigidaire washer/dryer. The dryer will not start at all.

Thanks for any info you can offer.