Unfortuntely my wireless network, aka airport express just went on the
blink while surfing. I contacted my ISP and nothing wrong their end,
and in anycase i have the cable connected directly into my macbook.
The express is flashing amber and I have resetted both hard and factory
with no joy. When i go into the airport utility, it seems to be the
default settings which might be amiss:
"this apple wireless device has default settings. you should configure
your apple wireless device to connect to the internet, secure the
wireless network and a provide a password"
So, how do I go about reconfiguring the network, or in layman terms, getting the darn thing working again?
You need to use the AirPort utility, which will walk through the setup and configuration of it. You were already on the right track to get it going. If it mentions there is an update available for it, though, do the update first.
I have a couple of problems.
My DVR-C300 will lock up and just spin. I can hear it spinning but the...
(More)
I have a couple of problems.
My DVR-C300 will lock up and just spin. I can hear it spinning but the movie doesn't play. Also it will freeze up on an image and again I must restart it by unplugging it from the wall.
Also the digital display does not light up so I can't read anything.
thank you.
-Orlando
picture/sound ok when viewing but both get jumpy when both tuners are used ie view & record...
(More)
picture/sound ok when viewing but both get jumpy when both tuners are used ie view & record simultaneously . signals seem OK but fault only apparent since digital switchover. a thomsom unit has been tried on same ariel and was OK. occurs even when unit has just been turned on
I have a standalone TiVo that uses the IR attachment to change channels on my cable box. I have gone...
(More)
I have a standalone TiVo that uses the IR attachment to change channels on my cable box. I have gone through the channel change test many times and it works fine. However, every so often, when it is time to record a show and it has to change the channel to record a program, the channel does not change. The IR attachment seems properly lined up with the cable box IR receiver and changing the channel via the TiVo remote control always works. This is frustrating and any suggestions would be appreciated.