Hi there. I just bought a ELITEGROUP G31T-M7 motherboard but dont know where to plugin the on/off button, onboard sound, usb ports and the led lights. Can you help please

you need to get a new board sorry to hear that or you can get a pci to ethernet card or usb plugin cheap 2 dollars

as long that it is the same pci x16 ver.

http://g31t-m7.com/

If your getting no beeps, its usually a video card issue. G31T-M7 has an onboard video card. Can you try plugging you montor to the VGA port and see if anything comes up. If still no picture, are fans turning? Might be a power supply failure.

http://download.ecsusa.com/dlfileecs/manual/mb/eng/p4/G31T-M7/G31T-M7_v7.pdf
Page 23

it sounds like a faulty lead i no that on a desktop one bad lead can cause a conputer lots of problems you might test all leads that are attched to your hard drive from your motherboard also the ones that attach to the drives cd/dvd 3.1/2 inch floppy drive or just replace them they might be faulty

Go into the control panel and select sounds and audio devices. Check to insure that the speaker volume is turn up and not muted. Also check for other audio control devices and check their volume settings. If you used the driver cd that came with the board download the latest drivers from the manufactures web site.

You have got an unnessacerily usb for your required mother board system.

i have a ecs g31t-m with a pentium e5200 dual core. i bought the board from ebay and the bios needed to be flashed before it would reconize the processor. after flashing the bios i still had the same problem. i found that in the user manual there is a list of "qualified" ram. before looking at this list i tried some ram that was not on the list and it wouldn't boot. after changing the ram to one that was on the list it finally booted up. however, after getting it to boot and reloading win xp, i cant get any drivers to load for the onboard equipment. so now i'm stuck. i hope this helps and if someone can give me direction on the drivers i'd be in good shape.

if your post code has completed so
heat problem or smps problem or ram problem or


remove all datacable exm : hdd ,writer,fdd and power on