Question about Pioneer SD-P55A5K 55" Rear Projection Television

2 Answers

Pioneer SD-P55A5 shut off during use and wont advance past standby mode

I was watching a program today and the screen went black and reverted back to standby mode (The light on the display went from green back to red).  If I turn the power completely off and back on, it briefly (less than a second) flashes green, and then back to red.  What should I do?  Thanks for your help!

Posted by on

  • barbssax Jul 28, 2008

    yes, but I do not understand how to reply for a follow up question...

×

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 446 Answers

Im afraid you are heading to somehow circuit problem, while you still have time and the warranty is still valid i suggest you send this back to the seller for a quick diagnostic, before its too late,

there is a problem with the power supply at this time, either by quickly repairing, or immediate replacement

Posted on Jul 28, 2008

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Expert
  • 83 Answers

This is a problem related to the hue controlls in the TV. It is quite common.

Fix: You can go into the TV settings and try adjusting the hue/tint there.

If adjusting settings does not work, request help from a technician to fix it for you since it will take adjusting the hue internally and if you do not do it correctly it can damage your television.

I hope this helps ya!

Posted on Jul 28, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Tv shuts off go on standby wont power back up


make sure it is pluggen in all the way to the source of video or may need new cord

Nov 24, 2009 | Pioneer SD-P55A5K 55" Rear Projection...

1 Answer

Tv only stays in standby mode


Replace Fuses 302 5amp and 303 5 amp Resolder all poor connection on power supply board and Replace Both STK ICs they are big black ics STK392-180s is best ICs Call Mats 1-800-628-1118 This should have you back to watching TV again.

Sep 19, 2009 | Pioneer SD-643HD5 64" Rear Projection...

2 Answers

Pioneer sd-643hd5 fuse issue


The fuses may not be your problem--I have fixed several of these---The large power board is on the right side as you look from the back?

Lots of these sets develop bad solder connections on that board--several sites on the internet offer to have you remove and send them the board to resolder--this set used lead free solder and after some years has problems--a few I have opened had clearly broken solder joints--I usually in this case remove the board(mark all the many plugs and make a diagram) and solder almost all of it by hand----usually fixes this kind of trouble.

I do this here for free so if this information was helpful give me a vote here....I am here to help people.

If you have any questions or need advice reply to this posting here.

SD TECH

Sep 12, 2009 | Pioneer SD-643HD5 64" Rear Projection...

1 Answer

Sd-643hd5


Power SD inverter board it dead.It cost about $575 parts and labors.

Sep 02, 2009 | Pioneer SD-643HD5 64" Rear Projection...

2 Answers

Pioneer sd-582hd5 shuts off while watching


internal components probably need to be cleaned.... sounds like a problem with t.v. overheating

Jul 11, 2009 | Pioneer SD-532HD5 53" Rear Projection...

1 Answer

Pioneer SD-582HD5 - screen went black, no sound, Poor remote feed


The blue tube might be leaking coolant in the high voltage area, that is the cause of the POP. This repair might not be a DIY because of the lethal high voltage surrounding the CRTs tubes.
The slow response from the remote could be because the coolant has affected the main board where the IR signal are going to the remote sensor.
Let me know if you require further assistance.

Dec 20, 2008 | Pioneer SD-582HD5 58" Rear Projection...

2 Answers

SD-532HD5 TV shuts off when watching


Its is a cold solder joint on the board. The board is the one located at the bottom right of the tv when looking at the rear. Mine did the same thing. After refreshing mose of the large solder pints on the board, it stopped. Hope this helps!

Nov 11, 2008 | Pioneer SD-533HD5 53" Rear Projection HDTV

1 Answer

Pioneer sd-t50w1


My SD P 50A3-K We unplugged it and now wont come back on to stay...we turn it on then the red lite comes on green flashes on then right back off.....Some times tv will come back on then it shuts it self off....please help thank you

Jun 30, 2008 | Pioneer SD-P50A5-K 50" Rear Projection...

1 Answer

Pioneer SD-P55A5 Shuts off and must be reset with Main Power Switch


if you are not a tech take your set to be repaired your tv illness is in the power supply or related circuit.good luck.

May 14, 2007 | Pioneer SD-P55A5K 55" Rear Projection...

Not finding what you are looking for?
Projection Televisions Logo

167 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pioneer Projection Televisions Experts

Jaime Hernandez

Level 3 Expert

2267 Answers

yadayada
yadayada

Level 3 Expert

61060 Answers

zorbrack

Level 1 Expert

19 Answers

Are you a Pioneer Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...