When i click red light indicates in front and near camera to video camera a red light blinks

THIS IS A NORMAL THING FOR UNIT TO DO
GREEN IS POWER APPLIED
AND RED IS HARDDRIVE RECORDING VIDEO DOWN

hi yes i would thanks

shaun

Flashing red could indicate dew sensor (camera has condensation/ damp) or other fault. See your manual Troubleshooting section.

Because the camera is what is technically known as 'Portable'and is designed to work purely from the internal battery. the Power Adapter merely charges the internal battery

When the charger blinks it indicates is either charging or trying to charge.
A solid red light indicates a bad battery.

.

-Remove the battery cover on the back of the remote and press and release the red SYNC button inside the cover. The lights on the front of the remote will blink.

-Open the SD card slot cover on the front of the Wii and press and release the red SYNC button also.

-When the lights on the front stop blinking, the connection is complete. The light that is illuminated indicates the player number (3 and 4).

The red light on the front of the camcorder is supposed to blink when it is charging. That indicates that it is still charging, the light will stop blinking when it is fully charged. Other than that does it work fine?

sounds like a dead battery. Plug the origional charger into it and the front led (below the flash) should flash red. If the red led in the back of the camera flashes or stays lit, then you have the wrong charger plugged in. (the camera won't power up if the back red/green led is on when plugged in)

Your service manual on page 82 steps you through decoding the blinking
1) there are two lights on the front near the reciever of the remote signals (Temp indicator and Lamp Indicator)
2) If the Temp indicator is on then they recommend you contact a service center
3) If the Lamp indicator is on and the power light stays on (no blinking) then you need to replace the lamp. Otherwise it says to contact the service center.
4) Counting blinks with the lamp indicator (1 every 5sec - lamp will not light or is abnormal, 2 every 5sec - lamp voltage is abnormal, 3 every 5sec - lamp temp is too high, 4 every 5sec - other error)

Excellent visual acuity technique!! I try to teach that procedure.

IC F6629B is probably shorted and at least one other part will

be open, possibly a zener diode,a fuse,a resistor or combo.

The service diagram would help.Be sure to use OEM first quality

parts.Let me know if you need more help.