Question about GPS Devices

1 Answer

I have a gas crosley range. I have to use matches to light the pilot lite. One of the pilot lites is too high. The other is fine. What should I do? Can it be fixed? At the moment I closed the gas valve on it because the stove top gets too hot.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 163 Answers

My old pilot stove has a small screw by the pilot to adjust. I keep it just high enough to stay lit. MM85

Posted on Jul 26, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to adjust pilot lite on a furnace


Select thermostat to off. Take front upper panel off of furnace. Looking at gas valve you should see a flat head or straight slot screw. This is the cap to access the adjustment. Look at the body of the gas valve real close. You may need to put on your glasses or use magnifying glass. It should say pilot in very small raised letters. Remove the cap. Look down into access hole and you will see the adjustment screw. It is a nylon screw so be careful not to strip it out. Place the correct screw driver, should be a small phillips or straight head. Turn gas valve to pilot and depress. Light pilot. While holding down, adjust nylon screw clockwise until flame envelopes 3/8 to 1/2 inch around thermocouple. Replace cap. Select heat and verify pilot stays lit. If the flame doesn't stay lit most likely your thermocouple is defective. You can purchase at your local hardware or Home Depot. Length doesn't matter.The thermocouple is heated and sends a DC signal back to the gas valve. There is another screw cap on the gas valve that adjusts gas pressure. Do not try to adjust the gas pressure to the gas valve because you need a special instrument (manometer) to adjust pressure. This device measures the water colume of the gas. A qualified technician would adjust this to 3.5" WC. for natural gas or 11" for propane.

Dec 09, 2013 | GPS Devices

1 Answer

Green lite will not on . when unit is pluged in


press reset+power for 20 seconds, then release reset ank keep pressing power, it will turn on for 10-20 secs, in this time you must connect it to the pc. run tomtom home and make the upgrades that the program sais. must help.

Apr 20, 2011 | Tomtom One XL GPS Receiver

2 Answers

Set time on tom tom xxl


There are 6 screens in the "Change Preferences" menu.
"Set clock" is the 1st item on page 6. (As is the "Reset factory settings" option for problems that seem insurmountable :o)

Mar 02, 2010 | Tomtom ONE GPS Receiver

1 Answer

My gas heater won't come on. It's not the therocouple because the pilot is lite. The thermostat on the wall works for my AC. What do I do?


It's possible the gas is just turned off at the heater. Most gas heaters have a valve which turns off the burner while allowing the pilot light to remain lit.

Your heater should have a little decal that tells you how to start it up. It usually involves pressing a big red button while you turn the valve (to prevent accidental turn-on). If your heater has such a label, follow the instructions on it carefully, and the heater should come on.

If that doesn't work - then this is not a good problem to get solved on the Internet. Think about it: if you do something that causes a gas leak, you could be severely injured or killed just by breathing too much of the gas, or lose your home to explosion or fire.

Look for the restart label, but if you don't find it or you follow it and it doesn't work, PLEASE contact a trained plumber who handles gas. Good luck, be safe!

Oct 06, 2009 | GPS Devices

1 Answer

Screen on Street pilot III does not lite.


flat battery? does it start up when on a charger. If not try replacing the battery

Jul 23, 2009 | GPS Devices

1 Answer

Cannot rebot my 400 it shows a soft blue lite, but will not come on


if you dont get the splash screen at least then you could have either just bad backlight or more serious issues. can you see the image if you hold it sideways to a light? if not, you may be out of luck but if you do see some image and hear clicks when you touch the screen, you could take it to an electronics shop to see if they can fix the backlight.

Nov 10, 2008 | Fine Digital FineDrive 400 GPS Receiver

1 Answer

HP iPAQ Bluetooth GPS, IPAQ has no signal


I noticed now that the 'green lite' on my receiver does not come on at all. I can not find where I can get a replacement receiver

Sep 09, 2008 | HP iPAQ Bluetooth GPS Navigation

1 Answer

Caddy lite gps


can any one help me please !!! my caddy lite will not let me update any programs (well my pc wont) it says i have either a mobile phone suite or a blue tooth program stopping it. i dont as far as i know but cant find whats stopping it help me please cheers jon

Jul 05, 2008 | GPS Devices

1 Answer

Charging


hi,
did you know it charges through usb of computer you'll see the red lite on the unit cool and give it 4 hours

Jun 07, 2008 | Fine Digital FineDrive 350 GPS Receiver

Not finding what you are looking for?
GPS Devices Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top GPS Devices Experts

yadayada
yadayada

Level 3 Expert

61168 Answers

k24674

Level 3 Expert

7987 Answers

The Knight
The Knight

Level 3 Expert

68352 Answers

Are you a GPS Device Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...