My syma s107g gives a flash light in the circuit board and does not work

I would suspect a fault but check the batteries in the remote are fitted
correctly.

press the left button(LB(like on xbox controller spot))

well firstly you still have warranty on it, get them to replace it..

the blades are controlled by a motor and a gear system in the helicopter itself. The gear is broken or the motor is wedged in by the gear. or simply burnt out, You will need to open it to unwedge the gear and if it spins when you turn the gear, you need to replace the motor. Both blades use separate motors that's what allows it to trim (turn) when one set spins faster than the other, It goes straight when both blades spin at the same speed.

I have the same problem, worked twice with a steady red light but then back to flashing and no comms. Turned all the TV's and wireless network off to see if this would help but still no joy. Need a solution as these are really cool little toys !

i think yes but i don't know how to connect

i've a problem to connect my helicopter RC to my arduino
if you already have a solve for this problem can you share me?

Hi,
I have similar problem with my LS-208 heli.
Helicopter leds are blinking red/green, front white led is on, and tail leds are blinking too.
Remote controller red led is on as should be but helicopter doesn't respond to controller at all.
I followed instructions above with no success.
Anyone has a suggestion?
Regards, Yaron.

I just read a question like this, and it seems it should. It may take longer to charge though, but I am not sure. sorry I couldnt get you the link to the question like yours. ;)

Paul,

That light is the gyro-sync indicator. It flashes briefly when you power on as a reminder to set the helicopter on a stable, level surface. Once the on board gyroscopes sync-up and set the "normal" head orientation, the light stops flashing and the helicopter will accept control signals from the remote.

Hope I've helped,

PvT

You have to charge it up through the USB cord or the cord built into the controller. It's in the "crappy" instructions, so you clearly didn't RTFM.

i am having the same problem!!! did you ever find out what was causing it???