Question about Jl Audio 1000/1 Car Audio Amplifier

2 Answers

Jl audio/1, no sound output , it gets hot and turns off

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Novelist:

    An expert who has written 50 answers of more than 400 characters.

  • Expert
  • 108 Answers

Please check with a voltmeter to see if your speakers are wire to the correct impedence. Those JL Audio amps are stable in a 2ohm load for monoblock amps and a 4ohm load for stereo amps.

Posted on Aug 11, 2008

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 45 Answers

There is a short check all connections carefully.. im betting it is your speaker connections

Posted on Jul 27, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Amp turns on but no output


1 make sure its hocked up properly .2 see i if the protection comes on.. with out the speaker wires hocked up if it does the u have a bad amp.3 if the amp protection light is off with out the speaker being hocked up and after hocking up the speaker it comes on the u have bad wiring to your speaker or a bad speaker

Jun 14, 2013 | Jl Audio 500/1 Car Audio Amplifier

3 Answers

I cant get my jl audio w6 10s to give off much bass with the jl audio 500/1 amp


here is a manual for your subwoofers: http://mobile.jlaudio.com/pdfs/8-12W6_BDS.pdf

use the wiring diagram for 1.5? (1.5ohm) with 2 speakers. the diagram for 3 speakers will not work, because it would bring the load down to 1 ohm, and the amp cannot go below 1.5 ohm.

to set up the amp:

under "preamp output section", on the "output mode" switch, select "amp filter"

to set up the levels: start with the amp gain pretty far down- with the input voltage on low for line level outputs from the deck, and on high for speaker outputs from the deck. now turn your cd deck as far up as it will go until it distorts, then turn the cd deck down to just where it stops distorting. now, you can start to turn up the gain on the amp.

on the filters, youll prolly want the cutoff filter around 100hz @ 24db slope. start with the infrasonic filters off, but, if you do get into them, try centering between 30 and 60hz on either, and, possibly dropping the cutoff filter to 80hz.

Jan 31, 2011 | Jl Audio 500/1 Car Audio Amplifier

1 Answer

Power light on, no sound through sub, I'm reading high ohm output


Contact Eric @ Capital Audio & Electronics Repair 850-339-1130 we repair all name brands & all models Located in Tallahassee,Fl

Mar 15, 2010 | Jl Audio 500/1 Car Audio Amplifier

1 Answer

JL Audio 500/1 Amp, The green power light is on but no sound!


Check to be sure you are on the correct outputs on the head unit, and be sure the outputs do not have a separate volume control.

Mar 06, 2009 | Jl Audio 500/1 Car Audio Amplifier

1 Answer

I HAVE A JL AUDIO MONOBLOCK AMP 250


It indicating that the power output is too loud and possibility of speakers may get damaged if played at this volume for long periods. When the loudest sound is played the led light mightshow its loosing its brightness and dims in time with the sound level.......................sodeep

Jan 17, 2009 | Jl Audio 500/1 Car Audio Amplifier

2 Answers

Jl audio amp 1000/1 fix


IVE HAD 2 JL 1000/1S DO THIS TO ME EACH TIME ITS TURNED OUT TO BE A SHORT IN THE RCA IMPUT BUT ALSO CHECK YOUR RCA CABLES AND THE SUB INPUT ON YOUR HEADUNIT

Dec 22, 2008 | Jl Audio 1000/1 Car Audio Amplifier

1 Answer

Jl 500/1 no output audio


You can send it to JL Audio and they will fix the output stage you toasted and will also perform any mods or upgrades to bring it up to spec. This will set you back $ 180.00 plus shipping cost to send it to JL. I know it's expensive but you damn near get a whole new amp to rock your world. mark..

Dec 18, 2008 | Jl Audio 500/1 Car Audio Amplifier

2 Answers

JL audio 500/1 produces barely any sound


have you checked the input sensor on the amp?

Oct 28, 2008 | Jl Audio 500/1 Car Audio Amplifier

1 Answer

My jl Auido 250/1 amp


You may have a bad output on the amplifier. I would recommend taking it to a local electronics repair to have fixed, or visit a local stereo shop - preferably a JL Audio dealer. Visit their website at www.jlaudio.com to find a dealer near you. You can have your amplifier sent in to JL Audio for repair by an authorized dealer and you'll get a warranty on the repair work.

Sep 27, 2008 | Jl Audio 250/1 Car Audio Amplifier

2 Answers

Jl audio 250/1


ok what is the amp out put of your altanator and were did you hook the romte turn on wire two. It is usally blue.

Jul 20, 2008 | Jl Audio 250/1 Car Audio Amplifier

Not finding what you are looking for?
Jl Audio 1000/1 Car Audio Amplifier Logo

Related Topics:

130 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jl Audio Car Amplifiers Experts

matthew walsh

Level 1 Expert

69 Answers

Tygh Duval
Tygh Duval

Level 2 Expert

290 Answers

Matthew Spark
Matthew Spark

Level 3 Expert

1042 Answers

Are you a Jl Audio Car Amplifier Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...