SOURCE: hai sir iam using in intel d945gcnl desktop is
If it displays a message saying "A bootable device has not been detected " Please check that the IDE Cable from the CD-ROM is connected Firmly to the IDE Header as displayed above and also check whether the ATA cable from the Hard Drive is connected to the Serial ATA Header Firmly.
"If you are using two optical drives be sure to check whether Primary Master and Slave are configured properly using the Jumper" If you are using one CD-ROM don't consider about this.
SOURCE: enable to boot bootable usb drive,ga-945gzm-s2 motherboard
reset your bios inside your pc its a big watch battery take it out for 10 15 min then put back it if that does not work take out the battery again and if you see neer your battery was ther should be a small jumper its usually black and its plugged in your board it also should have 3 pins to plug it in when you take it out plug it in the next 2 pins (the miffle one will plug in aswell then put it back in the first pins again put battery back in an try to boot it should work...
6,328 views
Usually answered in minutes!
×