Question about Linksys Wireless-G Broadband Router

1 Answer

Unable to get the linksys to work.When I plug in the wires the first light doesn't come on. stays unlighted.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 397 Answers

Open out a paper clip, on the back of the router is a tiny button marked "reset".
Pull the power cord out of the back of the router, now using three hands, one to hold the router, one to hold down the little button switch (with the opened out paper clip) and the third hand to plug the power cord back in.
Push the button in, put the power cord back in and keep holding the button down for ten to twenty seconds.
This will set your router back to the factory defaults, if the power lamp or any of the other lamps dont light up you will either have to return the unit to Linksys or if you can access the routers setup page you can do a firmware update.

Posted on Jul 24, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wrt54gx2 won't stay powered up


Has the AC jack been damaged in the Linksys, due to pulling of the cord? Try wiggling the plug at the rear of the linksys to verify the connection. Check, reseat ALL cables. If it's connected to the ISP modem, can you use a Ethernet cable on the Linksys to the computer to verify signal? It may be bad, hard to say for sure.

Feb 14, 2013 | Linksys Wireless-G WRT54GX Router...

1 Answer

NEED A WIRING DIAGRAM


go to the junk yard with a camera take a pic of the wiring harness then go back an match them up

Feb 07, 2013 | Cars & Trucks

1 Answer

Wireless router is not working


Go to Here for Linksys EasyLink Advisor (LELA). With this software you can monitor the routers status and troubleshoot.

Most trouble shooting involves disconnecting the power to the cable modem and the wrt54 router for about 10-20 seconds. Then plug in the modem until it lights, then plug in the router. The Advisor will then get a new address.

It also shows a graphic picture of your whole system.
81ec37f.jpg

I have a wrt54 and use this whenever I have a problem. I fix it then turn it off.

Hope this helps.

Good Luck

Feb 19, 2010 | Linksys Wireless-G WRT54GS Router...

1 Answer

Volks wagen golf diesel tdi Nreg


Check the glow plug thermo sensor...found in the cylinder head.
Unlightly anything wrong with injector pump.
Good luck
John

Feb 15, 2009 | 2002 Volkswagen Jetta TDI

1 Answer

Re-installing my linksys


Before you can use your linksys router again, you must configure first your AT&T modem under bridge mode. If the AT&T modem is already set to you may connect the devices (modem router and PC) must be switched OFF first.
after the devices had been connected,...
1) turn ON the AT&T modem first, wait for the DSL light to stay solid
2) turn ON linksys router,wait for the lights to stay solid
3) turn ON computer,wait for your desktop screen
4) try to access Internet Explorer

Nov 13, 2008 | Linksys Wireless-G WRT54GS Router...

1 Answer

A lot of problem WRT54GR with DHCP, gmail, hotmail, google earth, deezer.com ...


Try settings up the MTU to manual.

1500/1400/1300 for cable connection.
1492 for DSL. if this may not work then yes, you need to upgrade the firmware.

Aug 21, 2008 | Linksys Wireless-G WRT54GR Router

1 Answer

LINKSYS Wireless-G WRT54GS V7


Knowing Linksys products fairly well this an axact problems that I've had in the past. Sorry to say this but the internal circuitry has gone bad. If you call linksys thewy will do a cross ship exchange. Meaning if you give them a credit card they will send a new unit and you send the older unit. If your out of warranty they still sometimes do this out of courtesy. Thier tech support number is (800) 326-7114.

For the second guy, if the lights stay constantly lite it's the same problem


Jeff

Dec 01, 2007 | Linksys Wireless-G WRT54G Router...

Not finding what you are looking for?
Linksys Wireless-G Broadband Router Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Linksys Computers & Internet Experts

Prashant M
Prashant M

Level 3 Expert

2260 Answers

Les Dickinson
Les Dickinson

Level 3 Expert

18381 Answers

mark

Level 2 Expert

105 Answers

Are you a Linksys Computer and Internet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...