Blinking at 50 even though I focus to 28 and 105?

Ignition misfire, leaking intake gaskets, faulty fuel injector. Is the check engine light on and blinking with engine running?

get you manual and see it it is blinking the code for lamp. call Panasonic even though it's older it might be coved under LIFI lamp repair warranty. 1-800-211-7262

Hope I can help with some input to your problem. Let me suggest please that you switch the "mode" dial to "P" for program, check your ISO (I personally shoot ISO 100) and set it for a speed ISO 400 or lower. Most DSLR's use contrast to focus so a mirror, chrome, flat body of water, painted wall especially a white wall are just terrible to get an auto focus on. Also auto focus isn't going to happen in darkness unless you have (for Canon) an external Infrared auto focus assist beam. Also you could be to close to your subject as in attempting to do close up or macro photography and have over extended your lens capabilities.

You aren't doing anything wrong it's just I think that you have fallen into one or all of the above situations that auto focus just can't read being either dark, lacking contrast, or reflective surface or to close to your subject.

I wanted you to get off the full auto so you could enjoy the Rebel and expand on its features shooting in full auto turns it into a very expensive point and shooter. Shooting in "P" you can do what is called Program shift where you actually input settings into the camera before the picture is taken.

That little green dot focus confirmation will work even in manual mode so even though it might look out of focus to you if that dot is green and solid not blinking then it's in focus squeeze the shutter make the shot.

One other bit of information make sure you shut the IS off before mounting the camera on a tripod. if left on it will actually cause more vibration (that took me a while to figure out) have a great day hope this was a help sorry it took three days for me to find you with this problem Robert in Canada

Hi,
Yes, its clear symptoms of weak lamp that is going to end of its working life, soon tv will show you lamp light.
Replace lamp to solve the issue, lamp replacement procedure is easy and written in user manual.
Please buy Sony original lamp for good picture in tv.
Thanks.

the fuse is broke

A Blinking Lamp LED is the most common failure indication. It can be caused by a bad lamp, a bad Ballast, Color Wheel not operating, Fans not turning, or even other defective Boards. I would suspect the Ballast or fan first though.
Hope this helps,
Skyassoc

if you have another usb port, try that one... or try another computer... even though the software is not on it.. it will be recognized as an USB mass storage device

check the fuse, if its ok youre gonna need a new pump.

my apple shuffle ipod was not working and i am unable to listen the songs it araises a problem of glowing orange and green light plz tell me the solution for this problem

The shutter button features a two-stage action. Pressing Halfway Pressing halfway automatically sets the exposure, focus and white balance.
The indicators light or blink as follows.
Upper Indicator
" Green: Metering complete (two beeps sound)
" Orange: Flash will fire
" Blinking Orange: Camera shake warning / Insufficient exposure
Lower Indicator
" Yellow: Macro Mode / Manual Focus
" Blinking Yellow: Focusing difficulty* (single beep sounds)
* When the indicator blinks yellow, lock the focus before shooting.