How do i replace heating element in a zanussi washing machine

Ed4 - means:
Relay that switches the power between the washing and drying heating element (in the WD PCB).
Could be:
Wiring faulty; Electrical current leak between heating element and
ground; WD board faulty; Main PCB faulty
When this malfunction occurs the cycle stops with door open.

Dado

E33 - Inconsistency between level on electronic
pressure switch and level on anti-boiling pressure
switch 1(fault persists for at least 60 sec.).

• Pressure switch defective
• Electrical current leak between heating element and ground; Heating element; Wiring defective;
• Main board defective.
• Water circuit;

When is this fault occurs than will be performed emergency drain procedure, cycle stops with door unlocked.

Dado

Most often that I have found that when a dryer doesn't heat it's not the heating element. But more often one of the temp limit switches. Either the upper or lower limit. An ohm meter can check these.

You will have to purchase the heating element which for your model might look something like the one shown on this site.

Washing Machine Heating Element with Sensor
The instructions to replace this should come with it.
If not then try to download instructions from here which is usually similar for most European front loaders like yours.

How to replace washing machine element front mounted in Bosch washer

Just for the record, the heating element went on mine too and I'd only used it less than half a dozen times. The engineer said that it went because it hadn't been used enough (it gets moisture inside somewhere). He said if I didn't use it I would have the same problem after it had been replaced. So make sure you dry something every couple of weeks (he said at least once a month).

This is most likely caused by a faulty heating element in the washer, you need to check it over and replace it .

This will be the dryer heating element needs replacing.
Hope this helps.

hi yes they are different the fc1200w element is 1600 watts (£31 part 150867200-1)the jetsystem zwf1658 1900 watts its always better to use the correct part.

Hi,

I've got this machine, and all washer dryers tend to have two heating elements and it sounds to me that the heating element for the drying side of the machine's functions needs replacing. You could probably find a cheap element for the machine somewhere and get it fitted for a small sum.

Let me know if this rectifies your problem

WD Pro

u need to take the back half panel off once off u will see the two thermostats and the heater element you can test the element by undoing the wires and getting an old wire with plug on 1 end and bear wires on the other place corrisponding wires to were that wire had come of turn plug on and if it is working it will heat up straight away which means the thermostats need replacing if it doesnt then the element needs replacing