- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
Unplug everything and plug it back on, the camera power supply. now if it keep beeping go into you system and reformat your Hard Drive call them USA Telephone Support: 1800 627 2799 they have very good tech support 24/7 even if your dvr is old....tekgods
To perform a soft reset on your Pixi, press the OPT + SYM + R keys at the same time.
A master reset will return the handset to the default factory settings and erase all personal information on the handset. This type of reset should be used as a last resort to fix major errors, and all important information should be backed up before proceeding.
To perform a master reset go to the card view and tap launcher, it looks like a house. You need to swipe left 3 panels or until you find Device info. Scroll to reset options and tap. Scroll to and tap Full Erase. Warning this erases all data on your device, use only as a last resort! Read the warning then tap erase. The Pixi will reset and then restart.
Of course the possibles were checked for. Contaminated shoes, overly adjusted tight, shoes installed backwards(short shoe faces front), resurfaced drums that actually have a thread like groove to them that acts like a nut(turned too fast and horizontal set too high), front fluid flow restricted via hoses or bent lines, shoe hold downs ???? What was reason for master cyl. replacement? Was the same problem present before? If simply leaking and problem occured after replacement I'ld say bad master. Proportioning valves rarely go out. However they can get air bound and don't bleed correctly. You must hold in or out on reset valve till accomplished. Usually detected by variation in bleed/flow rate. Check over and report findings. The more info the closer the diagnoses.
I've seen bulging capacitors inside this modem causing me problems. Changed the caps and everything was OK for a couple of years after that. Started to have more problems with this modem recently, called phone company and sent me an new modem. Problem solved.
Also, it seems this old modem does not like the newer routers (D-Link DIR-615). It connected for a while, (30 seconds) then lost connection completely until power was cycled on model. The modem worked OK with older D-Link Router.
If you are using a cable to connect to the net, then remove the pair and remove the top 1/2 inch and expose the copper wire and plug it back. Also check with your ISP for dns settings..................sodeep