Have a beta 57a it wont work ? nothing - Shure SM87 Professional Microphone

are you using an interface?
Your level will be always be lower if you are going straight in.
Your interface and mixer will help you get the correct level in to your system before recording and also shaping the sound after the recording.You just need to get more gain up in there

Open it back up sounds like when you resoldered the cable you may have crossed onto another track or connection and are getting cross over bleed.

You'll probably need to send it to Shure for repairs. Contact your local Shure office.

Hi,
Here is a tip that will help you to figure out what is wrong with yourMicrowave Oven....

Microwave Oven Basic Troubleshooting Tips

heatman101
57a

The warranty is two years, so that is gone. There is a C-clip on the top that holds the cartridge into the handle. You'll need some C-clip pliers to remove it. Then the cartridge can be slid out to see what is inside. Otherwise, you can send it to Shure Service and they will repair it for a flat fee. Information is at www.shure.com/service

Try removing the XLR connector and removing the cartridge to see if there is anything loose inside the handle.

Hi,

Please check if the gain in the microphone is open.
Ther's a little hole where you can adjust the gain.

Good luck,
Gerard

They will fix it out of warranty. You will have to pay a flat rate plus shipping. Details are at www.shure.com/ProAudio/ServiceAndWarranty/ServicePolicies/index.htm. Your alternative would be to take it to a Shure dealer and have them replace the entire cartridge.

Restore your system to the date when your web cam is working.

My experience with the RCA F27242GY 27" TV going on and off is as follows:
Where the coaxial cable connects at rear and the base of the TV chassis part # 15062-57A is loose.