Question about Maytag PYE2300AY Electric Dryer

2 Answers

Maytag drier model MDE5806AYW

My drier is 18 months old. It shuts itself off in about 30 seconds. Until today, it has worked fine. The only thing out of the ordinary I can think of that has happened was a lightening storm last night.

Posted by on

  • lil_guy009 Aug 28, 2008

    Exact same problem with my dryer, it will turn on for 3-10 seconds and then shuts off. We also had a lightning storm last night and lost power for I don't know how long. Coincidence? I think not. Our dryer is also only about a year old.

×

2 Answers

It's actually the circuit board. The lightning struck near our house and the power went out. If we were to get a new circuit board the dryer would work fine. The lightning must have short circuited it. Which means the dryer wasn't properly grounded...

Posted on Sep 17, 2008

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 943 Answers

Hi thanks for the question i would guess the motor but man thats a hard one if the dryer was hit by lightning it could have caused a fef problems myself i would call my insurance company tell them you were hit before you call the insurance check all appliances in your house you may find other problems thanks the appliance doc

Posted on Sep 16, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Replace belt on maytag dryer lde8824ace


If it is a model where the belt goes around the drum rather than a separate pulley the drier must be dismantled far enough to allow the belt to be freed from the drum.
Belts need to be replaced so infrequently manufacturers make little provision for in-service replacement and generally the drier must be taken back to the stage in production where the belt was originally fitted.

This can be a rather extensive process with many models and in the absence of dedicated model information we often must resort to simply keep removing screws until the thing falls apart. By the time a belt needs replacing the drum bearings and/or seals are often generally in need of attention in addition that the extra work, though inconvenient and dispiriting, is rarely wasted.

Feb 08, 2015 | Maytag Dryer Drive Belt - Y312959

1 Answer

Intermittent Start (expanded explanation)


Lint will jam the start/run switch on the motor. Vacuum out the motor real good and check that the switch moves freely, and all the wires to it are plugged in good.

Nov 30, 2013 | Maytag Dryers

1 Answer

Intermittent start


Not a thermo fuse sound like motor is struggling.
May just need taken apart and cleaned

Nov 30, 2013 | Maytag Dryers

1 Answer

I have a MEDC400VWG drier.Woked fine yesterday. Put clothes in it today. Pushed start button. nothing happened. Smelled somthing getting hot. opened drier. Heating coils lit up. (with door open). Turned...


Sounds as if the motor centrifugal switch is stuck. Check to see if lint built up around switch or centrifugal mechanism on motor shaft. Rap switch with the handle of a screw driver hard but don't break it .

Nov 01, 2010 | Maytag PYE3300 Dryer

1 Answer

I have a Maytag Dryer model # MDE5806AYW Quiet Series 200 today we had to replace the belt but we took the top panel off the dryer including the control panel and disconnected the wires but now i forgot...



http://www.apwagner.com/large_image_viewer.php?image=images/diagrams/00191/i385263.GIF


Here is the link to the wiring diagram for your dryer, I'm assuming you are looking for the wires as they connect to the incoming power cord? They appear to be the only ones with that specific wire color code.
Hope this helps!

Jul 13, 2010 | Maytag Neptune MDE5500AY Electric Dryer

1 Answer

No heat


While your model number is not listed on the Service Manual at the link below, you will find information on how to check out the heater on page 8-6.

Good luck

http://www.servicematters.com/maytag_library/docs/16023110.pdf

Sep 29, 2009 | Maytag MDE16CS Electric Dryer

1 Answer

Drier keeps shutting down.


I had the same problem, they wear out in the rear bearing slot and drag on the front slides, So I bought Sears heavy duty model and it was was running better than ever until my wife took it away when she left me. Hope this helps

Feb 02, 2009 | Whirlpool LER4634J Electric Dryer

3 Answers

Maytag Neptune Dryer MDE5500AYW beeping and resetting itself


Ok , I replaced the control board. Still beeps continuously. Just sitting there, nothing else is on, just plugged in......beeep,beeeep,beeeeep,WTF man? I am about to turn this damn thing into an anchor and invest in more clothes lines! Maytag sucks. MAYTAG an acronym for...
Maybe
All
Your
Technicians
Agree;
Garbage...

May 16, 2008 | Maytag Neptune MDE5500AY Electric Dryer

1 Answer

Dryer turns itself on & beeps, then off again


aye, see if you can enter the diagnosis mode. What we are looking for is the F-02 code. This will flash when there is a stuck button or user interface problem and only displayed in the test mode. With the unit plugged in and all indicator lights off, select any button except stop. Press for 3 seconds, release for 3 seconds, press for 3 seconds, release for 3 secnds and press for 3 seconds. If you did it right 88 should appear. Press the same button again and if there is a error, it should show up. If no error code shows, open the consol and check the p-5 connector. This will be the interface ribbon to the board. Reseat it and see if the problem stops. Catriver

Jul 16, 2007 | Kenmore 67082 Electric Dryer

Not finding what you are looking for?
Maytag PYE2300AY Electric Dryer Logo

Related Topics:

271 people viewed this question

Ask a Question

Usually answered in minutes!

Top Maytag Dryers Experts

Mike Cairns
Mike Cairns

Level 3 Expert

3053 Answers

Dan Webster
Dan Webster

Level 3 Expert

8205 Answers

Tim Whalen

Level 3 Expert

3069 Answers

Are you a Maytag Dryer Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...