Question about Audio Players & Recorders
HI, MY MANE IS WILLIAM, AND ALSO HAVE AVN 5435, AND EVERY TIME I TURN ON THEY GIVE ME A MENSSAGE SAID , ( SECURITY), check the map disc............my email is email@example.com
Posted on May 14, 2009
I had to take my system completely apart to remove the DVD. Too much of a pain for me!
Posted on Oct 09, 2008
We lost the map disk we ned download
Posted on Aug 02, 2008
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
May 19, 2012 | Panasonic DVD Home Theater Sound System...
Sep 13, 2011 | Audio Players & Recorders
Sep 09, 2011 | Audio Players & Recorders
Mar 20, 2011 | Audio Players & Recorders
Mar 14, 2011 | Sony Audio Players & Recorders
Feb 28, 2011 | Audio Players & Recorders
Feb 16, 2011 | Audio Players & Recorders
Your no disc error can be a DIY like the
Assuming that the disc is good.
1.Clean the lens. - Sometimes because of dust the lens can't read any disc. Try clean the lens by soft cotton buds. Be careful while doing this.
I've suspect that the lens is filled up with dust. Below is just for your guide.
2.Replace the ribbon - Check the ribbon connected to the lens from the main board for scratch, damage. Once it has an open line then of course the lens can't read the disc. Also try to erase the contact by pencil eraser. If you've done the steps above and the symptoms still there then the next step requires you a little knowledge in soldering technique and reading the ohmmeter.
3.Check the motor - Check the motor that spin the disc with an ohmmeter. You can test it using the ohmmeter (x1) even it is connected on the lens assembly.Good motor - reading should be fairly high and it will spin. Bad motor- reading will drop to low resistance and will not spin.
Hint : 50% of my repaired unit the above parts are commonly caused of the problem.
If you confirmed that you have a defective motor then replace it with a new one. Before replacing the new motor you have to check the clearance of the disc holder with the old one. The clearance should be the same as the old because if not the lens will not read the disc if it is too far or too close.
Ifyou already cleaned the lens, and confirmed that the ribbon is good as well as the motor then I've advice you to send it to repair shop because the next step should be done with an expert because it is quite technical diagnosing the fault between the pick-up lens and the main board.
Hope it may help you.
Have a nice day!
Feb 06, 2011 | Audio Players & Recorders
Oct 11, 2010 | Audio Players & Recorders
Nov 28, 2009 | Yamaha RX-V2700 Receiver
730 people viewed this question
Usually answered in minutes!