Question about RCA P52926 52" Rear Projection Television

1 Answer

Turn off and on but doesn't stay on

Well turned on the tv set today and all it did was hear it turning on then 3 seconds later it turn off but the tv does not want to stay on what could be the problem? the serial# of the chassis is itc222.

Posted by on

  • nita26 Aug 13, 2008

    when i turn the tv on it turns right back off and no pictue you just see a black screen could it be the power supply.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

  • Expert
  • 230 Answers

Replace capacitors and standby pwr supply . This value ( important) 2200uf 25v, (2 suggested)1000uf 35v and 220uf 50v . Replaced and you will fixya!!. Am here for questions ok?. Thank you

Posted on Aug 13, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My tv, when plugged in just keeps turning itself on and off in intervals of about 3 seconds. It doesn't give time for anything to come up on the screen at all.


Problem is in standby power supply or microprocessor area---not the do it yourself repair and likely not economical to repair due to age and brand of set.

Sep 01, 2012 | Philips 60PP9352 60" Rear Projection...

1 Answer

My Hitachi TV turns off after a few seconds


not likely a do it yourself repair--take it to the shop.

Jun 14, 2012 | Projection Televisions

1 Answer

Tv wont turn on


hold the menu and input/device buttons for 5 seconds and it will blink you a 2 digit code
1-2 normal operation
2-3 i believe is short circuit protection = probably a convergence failure
here is a link to my tutorial
http://www.fixya.com/support/r5001731-convergence_diagnosing_convergence
Let me know if I can be of further assistance.

Jun 20, 2010 | Mitsubishi WS-55809 55" Rear Projection...

2 Answers

TV turns on, then turns itself off about 2 seconds later.


set has a self diagnostic---after set does shut down press and hold MENU AND DEVICE(INPUT) buttons on front of set for 5 seconds----if 2 blinks, a pause and 2 more blinks: this is short protection error code---The set does use 2 Stk394-250 and each is protected by a pico fuse in the power supply---if either fuse is blown the set will shut down(it detects no voltage or missing voltage;) It is not uncommon for a shorted IC to cause this problem; if you locate the STK's look carefully at the resistors around them---if any are discolored or burnt---you have found your problem.

Aug 17, 2009 | Mitsubishi WS-65413 65" Rear Projection...

1 Answer

Mitsubishi VS-50609 won't turn on


What a great tv this is Mitsubishi did a fine job making this one, but......only an authorized mitsubishi servicer should repair it. This set records diagnostic led codes that the technician receives to help determine where the problem might be, not the problem, but in which circuit it might be. The one thing to try is, unplug the tv , let it set for a minute, plug it back in , turn it on and hope it reset the micro. Next , call for mits. service.

Jun 11, 2009 | Mitsubishi VS-50609 50" Rear Projection...

1 Answer

Wont stay on after power is hit


Hello, I believe this may be a HV/LV power supply problem since this is a common issue in this RCA ITC222 chassis, I posted this earlier and I beleive that it can help you, Hello This is a common problem with the ITC222 chassis, I would check CP120, CP140, CP150 to see if they are bad I suspect CP150 is the one that is bad. Its value is 2200uf 16VDC. It is located on the same board as the IHVT and is in between the Heat sink in the middle of the board. I would also like to say that if possible you should get a qualified TV Technician to repair this set for you, due to the nature of this problem and the dangerous voltages present. I hope this helps, Shuttle83 http://www.electron-age-technologies-llc.com

May 30, 2009 | RCA D52W19 52" Rear Projection Television

1 Answer

TV turns off and on constantly.


this is the heat detection cicuit that detects when there is to much heat in the set , maybe cleaning it of dust, lint , ect.. will help

Nov 25, 2008 | RCA HD52W59 HDTV Projection Television

1 Answer

Power will not stay on


A problem in a certain parts or IC's on the board. You need a support technician for him to have a test inside the equipment. All parts have to be undergo into tester device to determine which is faulty.

thanks.

Feb 23, 2008 | Mitsubishi WT-46809 46" Rear Projection...

2 Answers

Mitsubishi TV WS-55511 Turns Off after Turning On


My mitsubishi big screen tv turns off in few seconds what should I do and I just got tv today please someone help

Oct 28, 2007 | Projection Televisions

1 Answer

TV turns on then right back off


If still under warranty or if you have no electronic repair experience you should take the set back to the shop or to a repair person. TV's are very hazardous to service. Even when plugged out, TV's can store very high voltages. Very possibly an electrolytic capacitor gone bad. You'll need to work on that, and then readjust the set. Not a major repair. good luck

Mar 15, 2006 | Pioneer SD-582HD5 58" Rear Projection...

Not finding what you are looking for?
RCA P52926 52" Rear Projection Television Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top RCA Projection Televisions Experts

The Wyzzyrd

Level 2 Expert

83 Answers

D. E. Hev

Level 3 Expert

1059 Answers

Ron Dufek
Ron Dufek

Level 3 Expert

398 Answers

Are you a RCA Projection Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...