Icemaker 200D1181G026 WR30X10061 model can15. Is there anyone who can test it and rpair it. It jst stopped working. Water supply ok.

Yes. On most refrigerator ice makers by the front panel on the right hand side there is a small screw adjuster that controls the amount of time that the water solenoid closes to admit water in. Adjusting it changes the size of the ice cubes from small to large or vice versa.

If you pull off the toe plate at the bottom, most of the time you will have you tech sheets attach to it. I think there is one for the ice maker. Sounds like a possible water valve bad

Yes, every time the icemaker cycles, it will switch in power to the icemaker water valve. the icemaker is pretty much a standalone device. All it needs is power and water supply, and valve. If it has both, and is not working properly, then the icemaker is bad.

it is hard to know what did happend to your unit but it can be check , and there is an arm that also turn the unit on or off but if you need to get new one the # is WR30X10061 for your unit and it is 120-160$

usually yes if no water to icemaker could be water valve solenoid. . first you can remove cover on icemaker and put the unit thru a test mode. find the plastic or medal cam in center of icemaker head when cover is removed., theis is a flateblade screw center get a small screwdriver and turn screw counterclockwise for about a 1/4 of a turn , icemaker will start cycling if icemaker ok then it will go througha cycle let it do its thing usually a few minutes for it to cycle, if fills you may have a bad icemaker, if no fill then valve may be bad. make sure you have good water pressure from your water supply that can cause icemaker problems.

Hi,
Try these steps

1. Check the shutoff arm
2. Check the supply valve
3. Inspect the water supply line
4. Test the shutoff switch
5. Check the freezer temperature
6. Inspect the ejector gear
7. Test the ejector motor
8. Test the ice mold heater
9. Test the holding switch
10. Test the water inlet switch
11. Test the thermostat
12. Test the water inlet valve

pls rate my suggestion.......

Check the following:

* Water supply to the fridge

* Open the freezer compartment and check to see if the water inlet fitting is frozen. It can be thawed out with a hair dryer....carefully

* If not the above, check the water valve, usually located on the lower back of the unit behind a cover. It may be malfunctioning or is plugged with debris

* Make sure the stop arm of the ice maker (inside the freezer) isn't stuck in the up position

First you need to find out if the lie is blocked. Disconnected water feed and try to run water through it into a bucket or sink. If you get water it is a valving problem. Also make sure the filter is clear.

verify the water supply to the valve first, second verify valve to icemaker works(unit has dual valve at rear bottom of fridge, switch plugs, then press water dispenser and see if icemaker fill with water ) if fills icemaker is bad , if not valve is bad. replace one or the other.

are u sure that model # Is right.. DOnt come up in any of my model data bases Seems like u might of got a bad icemaker.. if the water is coming into the icemaker from the water valve.. icemaker has to have power, to do that... all funtions after that would be controled by the iceaker .. The only other thing i can think of is your refrigerator has to be a certain temp to activate icemaker somewhere around 0 give or take some to be safe