Question about Hitachi 46W500 46 in. TV/DVD Combo

1 Answer

My tv no pic

My tv pic wont go on only vertecal line what parts gould be the proplem thanks

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Your vertical output IC could be faulty, or the FET that controls the vertical output could be faulty

Posted on Jul 20, 2008

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Tv dead red light wont stop flashing


Hi.

The TV starts in forced standby. The state is also called "Protect Mode", and kicks in whenever an internal fault is detected. The error is detected by controller circuit and the PSU is forced in standby mode, shutting down all voltage lines apart 5VDC to keep standby on.

First try disconnecting the power cord for ten minutes and restart the TV with no device connected.

If that does not help it means that there is an internal fault and that the TV must be tested and repaired replacing the defective part.

The defective part is usually the PSU. Components that fail quite often are the capacitors on the power board. If the capacitors look swollen or if there is trace of damage on PSU board, then the affected parts must be de-soldered and replaced. If there is no evidence of damage at a glance the parts must be tested using a multimeter and following schematics from service manual.

Regards.

Ginko

Jul 17, 2011 | Televison & Video

1 Answer

Horizontal hold troubleshooting. Can hear but pic is like a line on the screen. Tried adjustments on back


If the line is half way up the picture. This is a vertical problem. Most likely the vertical output IC or a bad solder joint near the IC.

Jan 26, 2011 | RCA 27F501TDV 27 in. TV/VCR/DVD Combo

1 Answer

When tv is turned on, only half of pic is there (left side)..The right side looks like a bar code, with horz. and vertical lines..There is color behind these lines....After it warms up or a couple hours...


This tv is a standard CRT(tube tv) wright?Yes,than the tv video board have problem with dying capacitors or the main colors decoders IC require resoldering.U have a soldering iron,a desoldering pump or a roll of desoldering braids,a roll of solders and also understanding basic electronic wright?Take the tv aparts check all those capactors all around the main colors decoders IC for capacitors leakages,replaced all these dying leakages capacitors,will solved this problems.These capacitors alway bulges up or puffing up on it top.That the indication those capacitors are dying and not working to it full capacity.Also resolders the colors decoders IC too.Ur tv problems,will be solved.

Nov 15, 2010 | Sylvania Televison & Video

1 Answer

My 46W500 Hitachi HDTv is blinking. The picture looks fine, but after about 10-15 seconds, on any given channel, the screen begins to blink. The blinking has a color pinkish tint. Can anyone help me out on...


The tv have a problems known as a convergence problems,it dead.The tv have colors lines R,G,B mis alignment,have colors shadows pictures or 3D pictures look alike.The tv convergence board have dead 2 STK convergence ICS and some or all it resistors are dead too.These parts,must be replaced on the tv convergence board to solved the tv picture convergence problems.The shop,will cost u like $300-350 for parts and labors.

Nov 15, 2010 | Hitachi 46W500 46 in. TV/DVD Combo

1 Answer

I have a RCA T25062 TV Combo problem is, it was connected to 220volts. Do you have a schematic of chasis? Regards George


If 220 volts was connected to it, you might be looking at a few parts to repair that wont be available. It looks like the main power transformer and line input transformer are no longer available.

Sep 16, 2010 | RCA T25062 25 in. Combo

2 Answers

Samsng stuck on line in


take the battery out of the phone for 2min and then put it back in and turn it on

Sep 21, 2009 | Samsung CXJ1964 19 in. TV/VCR Combo

1 Answer

Tv stays on after hitting the power button and remote stops working


it prolly is turned off but the image is burned into the screen

May 25, 2009 | Panasonic PV-C2020 20 in. Combo

2 Answers

SONY TV MODEL # KP-65WV700 SER.# 9002706


Blue Gun is right side of TV if you look in TV from back side. Part number is as follows..

8-733-663-25 {CRT 07MVC62(B)-L} [KP-65WV700 ONLY]

Mar 13, 2009 | Sony Televison & Video

1 Answer

Pic on tv


i problem with tv by that icant get pic from tv

Oct 28, 2006 | Samsung HC-P4363W 43 in. TV/DVD Combo

1 Answer

Connecting cable tv


What do you mean"but cable is still now working" If its working , what is the proplem?

Sep 07, 2006 | Sylvania 6319CA 19 in. Combo

Not finding what you are looking for?
Hitachi 46W500 46 in. TV/DVD Combo Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hitachi Televison & Video Experts

The Knight
The Knight

Level 3 Expert

69708 Answers

Donald DCruz
Donald DCruz

Level 3 Expert

17129 Answers

matt martin
matt martin

Level 3 Expert

1198 Answers

Are you a Hitachi Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...