Question about Sony KV-36XBR450 36" TV

1 Answer

TV Keeps flashing Fuzzy black and white static then the picture appears

Sometime the screen cuts inhalf half with fuzzy flashing black and white static moving and there will be a line down the middle with the bottom half black and white not moving. After about 5/10 minutes the picture will appear for about 5 minutes and it will go to the black and white screen again.
What should we do the sound is PERFECT.

Posted by on

  • Seafly Sep 21, 2008

    My 3 yr old 36" XBR has the same problem fuzzy split picture except at some point it will show the picture after 7 seconds, stays on for 30 seconds, and then repeats the cycle.

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 146 Answers

The half picture is a verticale problem. This is difficult to repair. Send to a repair shop.

Posted on Nov 15, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Tv 27" has only half screen picture horizional I


Possible failure of the VERTICAL SECTION of the deflection circuit. It is possible that the areas related to the vertical circuit is checked , check for weak capacitors near the output vertical drive. Also a faulty vertical coil- deflection coil- can result in half picture.
A vertical signal test can confirm.

Oct 16, 2011 | GE Standard (CRT) Televisions

2 Answers

Curtis Mathes TV


the convergence ic must be faulty

Mar 01, 2008 | Standard (CRT) Televisions

1 Answer

When using cable input video is good but sound has fuzzy static


Your TVs tuner tuned a little off frequency. It could be as simple as having cable box on where you have good picture but fuzzy sound, use the TVs remote to change the channel and then change it back to proper channel. If that doesn't fix you may have wrong tuning type selected in channel set up menu.

Oct 11, 2009 | Toshiba 27A30 27" TV

1 Answer

TV shows on half screen. other half fuzzy


You have some cold solder joints on the PC board. Flux and re-flow all of the electrolytic capacitors connections..

Aug 29, 2009 | Standard (CRT) Televisions

1 Answer

Blurry picture


If you know where the fly back is, ok open the casing and see at the back of the fly back, there are two knobs, one for the focus and the other is for the brightness. Try twist both and see which one is for the focus. Ok, from the focus knob try adjusting until the fuzzy sight disappears. Try this, I usually do it to screens with blurry appearances.

Nov 10, 2008 | Sony FD Trinitron WEGA KV-32FS120 32" TV

1 Answer

Sony triniton 28" crt tv i have got sound but no picture


Any set can be repaired it is the question of the cost and the availability of the parts.

The fuzzy lines with static noise is probably from an arcing in the high voltage multiplier or in the flyback windinngs. I am very sure that the flyback assembly with the high voltage multiplier, and most likely the horizontal output transistor will have to be changed just to start. It is also possible that there may be some failure in the power supply as well.

The set would have to be serviced by an experienced TV tech. As for the cost, it will be a bit expensive.

Jerry G.

Apr 20, 2008 | Sony FD Trinitron KV-28FQ75 28" TV

1 Answer

TV will not turn on


check the resistors and capacitors in vertical section of the television..or change the vertical ic.

Dec 29, 2007 | Standard (CRT) Televisions

2 Answers

TV picture


The set you have has a bad tuner assembly. At this point most likely you would be better off getting a new TV set. Good Luck

Mar 30, 2007 | Mitsubishi CS-27309 27" TV

1 Answer

ALL MY CHANNELS HAVE A BLACK PICTURE & FUZZY, PLEASE HELP


first off how good are you with a solder iron ? beside the obvious rf connector problem these set's had problems with bad solder connections within the tuner itself. google( sam goldwasser repair faq) for the solder template.

Jun 10, 2006 | RCA F27252GY 27" TV

Not finding what you are looking for?
Sony KV-36XBR450 36" TV Logo

910 people viewed this question

Ask a Question

Usually answered in minutes!

Top Sony Standard (CRT) Televisions Experts

The Knight
The Knight

Level 3 Expert

68368 Answers

Jaime Hernandez

Level 3 Expert

2267 Answers

matt martin
matt martin

Level 3 Expert

1191 Answers

Are you a Sony Standard (CRT) Television Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...