Question about Chamberlain Powerdrive PD422D 1/2 HP Security Plus Screw Drive Garage Door Opener

1 Answer

Garage door opener does not work

Hello,
The problem happened after we had a bad thunder storm. The opener has power but does not operate. Tried using the lerner features still no success.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

My Garage door goes down half the first time I'm attempting to close it; then closes completely the second try. What's the problem?

Posted on Jul 20, 2008

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My garage door opener beeps frequently but operating well. What is the issue & how can i resolve?


Hello,
Sounds to me like your backup batteries are low. The back up batteries are there for use should you use power. You can try this -
  1. Unplug the garage door opener.
  2. Get into the back up battery compartment.
  3. Now unplug the connector to the battery pack and replug it in. This might help but if you continue to have this beeping then you will have to replace the backup batteries. You will not suffer any mechanical problems unless your electricity goes out.
Regards, Tony

Apr 14, 2011 | Chamberlain Powerdrive PD422D 1/2 HP...

1 Answer

Went to my garage to get items out of freezer and my garage door opener was down, no one handle the remote, or push any buttons at all, went back to the garage to get bottle water and the door was wide...




Anytime a door opens and/or closes randomly or doesn't work consistently I look for a smashed wire between the motor unit and the wall button.


If the wire is smashed the insulation becomes so thin that power will leak thru the insulation and activate the door or interfere with the remote signal.


Loosen the staples with a small screwdriver and slide the wire about ?½ inch to move any areas of thin insulation away from the staples.


The second thing would be a bad wall button or a remote with a sticking button.

Or a remote in someone

Oct 30, 2010 | Chamberlain Powerdrive PD422D 1/2 HP...

1 Answer

Storm last night. Light comes on opener and the


HOLDING DOWN THE WALL BUTTON OVERRIDES THE SAFETY EYES.
WHEN HOLDING IT DOWN MAKES THE DOOR CLOSE PROPERLY THE PROBLEM IS IN THE SAFETY EYES.

ARE BOTH LEDS ON? - CHECK FOR A LOOSE OR BROKEN WIRE.
ARE THE EYES WIRED CORRECTLY?
ARE THEY AIMED AT EACH OTHER?

I WOULD RECOMMEND GETTING A SURGE PROTECTOR FOR THE NEXT TIME.

May 17, 2010 | Chamberlain Powerdrive PD422D 1/2 HP...

1 Answer

Programming multiple remote door openers I am trying to add a remote key pad to the exterior of the door. When that is programmed and working it knocks out the car remote. I have 2 of those. How do I get...


i think what is happening is the code in your open has a list of different codes it cycles through to keep someone from "capturing" it and opening the door when you gone.Try having someone help you and program the three units at the same time.

Sep 06, 2009 | Chamberlain Powerdrive PD422D 1/2 HP...

1 Answer

Light on, nobody home ??!!


The light flashing on the back of the operator 5 times indicates that there is an RPM sensor failure. They can be changed easy enough, but remember to unplug the operator first. The part # is 41C4398A. Your best bet would be to call a garage door company and get them to look at it. Your logic board may also be fried from the storm. Hope this helps.

Jan 31, 2009 | Chamberlain Powerdrive PD422D 1/2 HP...

1 Answer

Garage door opens after a power surge.


Unplug the operator for 2 mins.and remove the wires to the wall control. plug the operator back in if the operator starts running  the logic board is most likely fried (bad) and should be replaced.

Nov 23, 2008 | Chamberlain Powerdrive PD422D 1/2 HP...

1 Answer

Multi-Function Door Control


Take off the two wires on bad of button and touch together, If it works, buy new panel or doorbell button. If not, make a jumber with a paer-clip and touch W and R terminals. If that works, replace wiring to pushbutton. (Did it ever work? If not Red and White wires may be reversed)

Aug 19, 2008 | Chamberlain Powerdrive PD422D 1/2 HP...

5 Answers

Chamberlan 1/2 hp security + not working


sounds like it is out of synch.do you have a manual on this model

May 19, 2008 | Chamberlain Powerdrive PD422D 1/2 HP...

Not finding what you are looking for?
Chamberlain Powerdrive PD422D 1/2 HP Security Plus Screw Drive Garage Door Opener Logo

164 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chamberlain Car Audio & Video Accessories Experts

kcunningham2

Level 1 Expert

31 Answers

Iron
Iron

Level 3 Expert

3018 Answers

yadayada
yadayada

Level 3 Expert

61055 Answers

Are you a Chamberlain Car Audio and Video Accessory Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...