Weve got a hitachi 32ld6600 that wont switch on, the power light is flashing,but nothing else will happen,the problem seemed to occur after we recently had a power cut,can you help

These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices. http://electronicshelponline.blogspot.com/
Blinking codes details to many popular brand TVs are given. Surf the site with patience.

These blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices. Viewing it in "Mosaic" or "Magazine" will make surf easy.
http://electronicshelponline.blogspot.com/
Blinking codes details to many popular brand TVs are given. Surf the site with patience.

Flashes of blue light are fault indications. From the number of flashes occurs at one time switch on, you can get an idea about the faulty section circuit board inside. If you wish to get details about these blinks, check this link.

The lights are powered by the dimmer switch in the headlight switch box. Power goes from there thru a 10amp fuse number 12 marked ILLUM in the interior fuse box.
Then it goes out to the lights.
You would need to know if you have power at that fuse.

Those blinks [flashes] are fault indication (Error Codes). From the number of blinks occur at one time switch ON, you can get an idea about the faulty circuit section inside it. This will make repair easy. These are called blinking codes. Make sure about the exact number of blinking of the standby/power LED, by switching On & OFF the set, for at least two times. Count it carefully. If you wish to get some details, check the site linked here. It has details about blinking codes, and fault locating procedure, to many popular brand TVs and other devices.
http://homenol.blogspot.com/
http://electronicshelponline.blogspot.com/
If blinks continue without any pause, the main board is faulty.

Had this same problem myself. To get mine to start i have to push the door to until it starts.

lamp duration

batteries are dead,or not in properly.if not. only use energizer lithium batteries.others burn out very fast,hope i was helpful.

easy
you have to get your tv into "hotell" mode:

1 meny then type 1,3,2,5 and the hotel meny show...set it on and to start on ext5....close with meny...turn tv off and then on and your problem is solved

The "green light flashing to the chirping" circuit may be defective.

Not a basic diagnosis--service literature and/or knowledge of each green light circuit will be needed.Possible shop repair.